M30873FHBGP#U3 Renesas Electronics America, M30873FHBGP#U3 Datasheet - Page 123

• Manufacturer Part Number: M30873FHBGP#U3
• Description: IC M32C/87 MCU FLASH 100LQFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M32C/80r

Specifications of M30873FHBGP#U3

• Core Processor: M32C/80
• Core Size: 16/32-Bit
• Speed: 32MHz
• Connectivity: EBI/EMI, I²C, IEBus, IrDA, SIO, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-LQFP
• For Use With: R0K330879S001BE - KIT DEV RSK M32C/87R0K330879S000BE - KIT DEV RSK M32C/87
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

M32C/87 Group (M32C/87, M32C/87A, M32C/87B)
REJ09B0180-0151 Rev.1.51 Jul 31, 2008
Page 99 of 587
Figure 9.14
(1) Initial setting
(2) Before entering wait mode
(3) After exiting wait mode
NOTES:
1. Set each level to meet the formula shown as below.
2. Insert at least 4 NOP's after WAIT instruction.
I flag = 0
FLG register: set IPL
Bits RLVL2 to RLVL0 = the same level as IPL
Select the operating mode from the following:
-main clock mode
-low-speed mode
-on-chip oscillator mode
-on-chip oscillator low-power consumption mode
I flag = 1
RLVL register: bits RLVL2 to RLVL0 = 7
RLVL register: bits RLVL2 to RLVL0 = 7
Set the interrupt priority level (ILVL2 to ILVL0) of
(ILVL2 to ILVL0) > IPL = (RLVL2 to RLVL0)
Set the interrupt priority level of the interrupts,
Set an interrupt priority level of each interrupt
which are not used to exit wait mode, to 0
Execute the WAIT instruction
the interrupt used to exit wait mode
Procedure to Enter Wait Mode
Wait mode
Start
End
(Note 2)
Initial setting for the wait/stop mode
exit interrupt priority level
Interrupt disabled
Set the processor interrupt priority level (IPL)
Set the exit interrupt priority level (RLVL2 to RLVL0)
When the CM02 bit in the CM0 register is 1,
set bits MCD4 to MCD0 in the MCD register
for the CPU frequency to be 10 MHz or lower.
Interrupt enabled
Set the exit priority level as soon as exiting wait mode
9. Clock Generation Circuits
(NOTE 1)