DS26528GA4 Maxim Integrated, DS26528GA4 Datasheet - Page 225
DS26528GA4
Manufacturer Part Number
DS26528GA4
Description
Network Controller & Processor ICs
Manufacturer
Maxim Integrated
Datasheet
1.DS26528GNA4.pdf
(276 pages)
Specifications of DS26528GA4
Part # Aliases
90-26528-GA4
- Current page: 225 of 276
- Download datasheet (2Mb)
Register Name:
Register Description:
Register Address:
Bit #
Name
Default
Bits 5 and 4: Receive Impedance Match 1 and 0 (RIMPM[1:0]). These bits are used to select the receive
impedance match value. These must be set according to the cable impedance. Even if the internal receive match
impedance is turned off (RIMPOFF); the external cable impedance must be specified for optimum operation by
RIMPM1 to 0. See
Bits 1 and 0: Receiver Sensitivity/Monitor Gain Select 1 and 0 (RSMS[1:0]). These bits are used to select the
receiver sensitivity level and additional gain in monitoring applications. The monitor mode (RMONEN) adds
resistive gain to compensate for the signal loss caused by the isolation resistors. See
Table 9-18. Receive Impedance Selection
Bit 7: Receive G.703 Clock Enable (RG703). If this bit is set, the receiver expects a 2.048MHz or 1.544MHz
clock from the RTIP/RRING, based on the selection of T1 (1.544) or E1 (2.048) mode in the
Bit 6: Receive Impedance Termination Off (RIMPOFF).
Bit 3: Receiver Turns Ratio (RTR).
Bit 2: Receiver Monitor Mode Enable (RMONEN).
RIMPM[1:0]
0 = Receive terminating impedance match is enabled.
1 = Receive terminating impedance match is disabled.
0 = Receive transformer turns ratio is 1:1.
1 = Receive transformer turns ratio is 2:1. This option should only be used in short-haul applications.
0 = Disable receive monitor mode.
1 = Enable receive monitor mode. Resistive gain is added with the maximum sensitivity. The receiver
sensitivity is determined by RSMS1 and RSMS0.
00
01
10
11
RG703
7
0
Table
RIMPOFF
9-18.
LRISMR
LIU Receive Impedance and Sensitivity Monitor Register
1007h + (20h x n): where n = 0 to 7, for Ports 1 to 8
RECEIVE IMPEDANCE
6
0
SELECTED (Ω)
100
110
120
75
RIMPM1
5
0
RIMPM0
225 of 276
4
0
RTR
3
0
DS26528 Octal T1/E1/J1 Transceiver
RMONEN
2
0
Table 9-19
LTRCR
RSMS1
1
0
and
register.
Table
RSMS0
9-20.
0
0
Related parts for DS26528GA4
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Network Controller & Processor ICs Octal E1-T1-J1 Singl e-Chip Transceiver (
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Network Controller & Processor ICs Octal E1-T1-J1 Singl e-Chip Transceiver (
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
power light source LUXEON® Collimator
Manufacturer:
LUMILEDS [Lumileds Lighting Company]
Datasheet:
Part Number:
Description:
Single +5V, fully integrated, 1.25Gbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Single +5V, fully integrated, 155Mbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
MAX7528KCWPMaxim Integrated Products [CMOS Dual 8-Bit Buffered Multiplying DACs]
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
VRD11/VRD10, K8 Rev F 2/3/4-Phase PWM Controllers with Integrated Dual MOSFET Drivers
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Highly Integrated Level 2 SMBus Battery Chargers
Manufacturer:
Maxim Integrated Products
Datasheet:
Part Number:
Description:
Current Monitor and Accumulator with Integrated Sense Resistor; ; Temperature Range: -40°C to +85°C
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
QFN 16/A°/AC-DC and DC-DC Peak-Current-Mode Converters with Integrated Step
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
TDFN/A/65V, 1A, 600KHZ, SYNCHRONOUS STEP-DOWN REGULATOR WITH INTEGRATED SWI
Manufacturer:
Maxim Integrated Products
Part Number:
Description:
Integrated Temperature Controller f
Manufacturer:
Maxim Integrated Products