LPC1317FHN33,551 NXP Semiconductors, LPC1317FHN33,551 Datasheet - Page 27

• Manufacturer Part Number: LPC1317FHN33,551
• Description: ARM Microcontrollers - MCU 32bit ARM Cortex-M3 64KB Flash 10KB SRAM
• Manufacturer: NXP Semiconductors

Specifications of LPC1317FHN33,551

• Rohs: yes
• Core: ARM Cortex M3
• Processor Series: LPC1317
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 72 MHz
• Program Memory Size: 64 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 2 V to 3.6 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 260

NXP Semiconductors
LPC1315_16_17_45_46_47
Product data sheet
7.9.1.1 Features
7.8.1 Features
7.9.1 Full-speed USB device controller
7.10 USART
7.9 USB interface
Remark: The USB interface is available on parts LPC1345/46/47 only.
The Universal Serial Bus (USB) is a 4-wire bus that supports communication between a
host and one or more (up to 127) peripherals. The host controller allocates the USB
bandwidth to attached devices through a token-based protocol. The bus supports
hot-plugging and dynamic configuration of the devices. All transactions are initiated by the
host controller.
The LPC1345/46/47 USB interface consists of a full-speed device controller with on-chip
PHY (PHYsical layer) for device functions.
Remark: Configure the LPC1345/46/47 in default power mode with the power profiles
before using the USB (see
performance, efficiency, or low-power mode.
The device controller enables 12 Mbit/s data exchange with a USB Host controller. It
consists of a register interface, serial interface engine, and endpoint buffer memory. The
serial interface engine decodes the USB data stream and writes data to the appropriate
endpoint buffer. The status of a completed USB transfer or error condition is indicated via
status registers. An interrupt is also generated if enabled.
The LPC1315/16/17/45/46/47 contains one USART.
•
•
•
•
•
•
•
•
•
•
•
•
•
GPIO pins can be configured as input or output by software.
All GPIO pins default to inputs with interrupt disabled at reset.
Pin registers allow pins to be sensed and set individually.
Up to eight GPIO pins can be selected from all GPIO pins to create an edge- or
level-sensitive GPIO interrupt request.
Port interrupts can be triggered by any pin or pins in each port.
Dedicated USB PLL available.
Fully compliant with USB 2.0 specification (full speed).
Supports 10 physical (5 logical) endpoints including one control endpoint.
Single and double buffering supported.
Each non-control endpoint supports bulk, interrupt, or isochronous endpoint types.
Supports wake-up from Deep-sleep mode and Power-down mode on USB activity
and remote wake-up.
Supports SoftConnect.
Supports Link Power Management (LPM).
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 20 September 2012
Section
7.18.5.1). Do not use the USB with the part in
LPC1315/16/17/45/46/47
32-bit ARM Cortex-M3 microcontroller
© NXP B.V. 2012. All rights reserved.
27 of 77