DM9010BI DAVICOM [Davicom Semiconductor, Inc.], DM9010BI Datasheet - Page 34

• Manufacturer Part Number: DM9010BI
• Description: Industrial-temperature 10/100 Mbps Single Chip Ethernet Controller With General Processor Interface
• Manufacturer: DAVICOM [Davicom Semiconductor, Inc.]

8.6 Auto-negotiation Link Partner Ability Register (ANLPAR) – 05
This register contains the advertised abilities of the link partner when received during Auto-negotiation.
Preliminary
Version: DM9010BI--DS-P01
January 12, 2010
4.12-4.11
5.12-5.11
4.4-4.0
4.13
4.10
5.15
5.14
5.13
5.10
4.9
4.8
4.7
4.6
4.5
Bit
Bit Name
Reserved
Reserved
TX_HDX
TX_FDX
10_FDX
10_HDX
Selector
ACK
FCS
FCS
RF
NP
RF
T4
<00001>, RW Protocol Selection Bits
0, RO/P
Default
X, RW
0, RW
0, RW
1, RW
1, RW
1, RW
1, RW
0, RO
0, RO
0, RO
0, RO
0, RO
Industrial-temperature Single Chip Ethernet Controller with General Processor Interface
Remote Fault
1 = Local device senses a fault condition
0 = No fault detected
Reserved
Write as 0, ignore on read
Flow Control Support
1 = Controller chip supports flow control ability
0 = Controller chip doesn’t support flow control ability
100BASE-T4 Support
1 = 100BASE-T4 is supported by the local device
0 = 100BASE-T4 is not supported
The DM9010BI does not support 100BASE-T4 so this bit is
permanently set to 0
100BASE-TX Full Duplex Support
1 = 100BASE-TX full duplex is supported by the local device
0 = 100BASE-TX full duplex is not supported
100BASE-TX Support
1 = 100BASE-TX half duplex is supported by the local device
0 = 100BASE-TX half duplex is not supported
10BASE-T Full Duplex Support
1 = 10BASE-T full duplex is supported by the local device
0 = 10BASE-T full duplex is not supported
10BASE-T Support
1 = 10BASE-T half duplex is supported by the local device
0 = 10BASE-T half duplex is not supported
These bits contain the binary encoded protocol selector supported
by this node
<00001> indicates that this device supports IEEE 802.3 CSMA/CD
Next Page Indication
0 = Link partner, no next page available
1 = Link partner, next page available
Acknowledge
1 = Link partner ability data reception acknowledged
0 = Not acknowledged
The DM9010BI's auto-negotiation state machine will automatically
control this bit from the incoming FLP bursts. Software should not
attempt to write to this bit
Remote Fault
1 = Remote fault indicated by link partner
0 = No remote fault indicated by link partner
Reserved
Read as 0, ignore on write
Flow Control Support
1 = Controller chip supports flow control ability by link partner
0 = Controller chip doesn’t support flow control ability by link
partner
Description
DM9010BI
34