MT90222 ZARLINK [Zarlink Semiconductor Inc], MT90222 Datasheet - Page 59
MT90222
Manufacturer Part Number
MT90222
Description
4/8/16 Port IMA/TC PHY Device
Manufacturer
ZARLINK [Zarlink Semiconductor Inc]
Datasheet
1.MT90222.pdf
(155 pages)
- Current page: 59 of 155
- Download datasheet (920Kb)
4.5
In any framed modes, the Frame signal format can be one of two options. It can be of a generic format (active high
or low during the first bit of the frame) or ST-BUS format (active low at the boundary of the frame). In the generic
modes, the clock polarity can be selected to have a rising or falling edge at the bit boundary.
The TXCK and TXSYNC signals can be either outputs or inputs.
4.6
Two loopback modes are provided where the TDM RX inputs are internally routed back to the TDM TX outputs
(remote loopback) with the RX block fully operational, and where the TDM TX outputs are routed back to the TDM
RX inputs for test purposes (metallic loopback). The TX and RX links have to be programmed in the same mode for
the loopback to operate properly. Bit 8 of the TDM TX Link Control Register (0x0600-0x060F) controls the remote
loopback and bit 8 of the TDM RX Link Control (0x0700-0x070F) register controls the metallic loopback.
To use remote loopback, TXCK and TXSYNC must be configured as output sourcing from the RXCK and RXSYNC
of the same port. The loopback is on a per link basis with the limitation that physical links are paired: i.e., TX link 0
is connected to RX link 0 and so on.
Besides TDM loopacks, there is also a UTOPIA loopback described in section 5.7.
4.7
Each serial TDM link has assigned S/P and P/S units. The P/S unit takes a byte from the cell RAM and converts it
to a serial bit stream. The S/P unit takes a byte from the DSTi input and converts it to parallel format for use by the
Cell Delineation block.
P/S and S/P units can be set-up differently on a per port and per direction basis (i.e., the transmit and receive function
of the same port can use different configurations). The following features are supported:
•
•
•
•
•
•
•
•
•
When the TXCK and TXSYNC signals are outputs, the source for the TXCLK is software selectable from any of the
RXCK inputs or any of the four external REFCKs. The TXSYNC signal is generated from the TXCK and is
independent from (not aligned with) the RXSYNC or other TXSYNC signals.
programming links as T1 or E1
using ST-BUS and Generic TDM modes
enabling/disabling the P/S and S/P units (if they are disabled the associated outputs are Tri-stated)
selecting TDM timeslots as per mapping registers
independently programming the polarity of RXCK, TXCK, RXSYNC and TXSYNC signals (Generic TDM
mode only)
generating/accepting TXSYNC and TXCLK signals to support most T1 and E1 framers (depending on the
programmed mode)
monitoring RXSYNC signal period and reporting the unexpected occurrence of a synchronization signal
monitoring TXSYNC signal period (when defined as input) and reporting the unexpected occurrence of a
synchronization signal
generating a TXSYNC pulse on every TDM frame when defined as output
Clock formats
TDM Loopback Mode
Serial to Parallel (S/P) and Parallel to Serial (P/S) Converters
Zarlink Semiconductor Inc.
MT90222/3/4
59
Data Sheet
Related parts for MT90222
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Zarlink Semiconductor Inc [TV IF PREAMPLIFIER]
Manufacturer:
Zarlink Semiconductor
Datasheet:
Part Number:
Description:
Satellite Channel Decoder
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Power Factor Controller
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
CMOS/SNOS NVSRAM HIGH PERFORMANCE 8 K x 8 NON-VOLATILE STATIC RAM
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Dual stage IF amplifier for cable tuners
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Synthesized Broadband Converter with Programmable Power
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Cable Tuner Front End LNA with AGC
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Front End Power Splitter with AGC
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
1.3GHz Dual Wideband Logarithmic Amplifier
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Wide Dynamic Range Image Reject MOPLL
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND PLL FM DETECTOR FOR SATELLITE TV
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND LINEAR FM DETECTOR FOR SATELLITE TV
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND LOG IF STRIP AMPLIFIER
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND LOG IF STRIP AMPLIFIER
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
THIS DOCUMENT IS FOR MAINTENANCE PURPOSES ONLY AND IS NOT RECOMMENDED FOR NEW DESIGNS
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet: