MT90222 ZARLINK [Zarlink Semiconductor Inc], MT90222 Datasheet - Page 55
MT90222
Manufacturer Part Number
MT90222
Description
4/8/16 Port IMA/TC PHY Device
Manufacturer
ZARLINK [Zarlink Semiconductor Inc]
Datasheet
1.MT90222.pdf
(155 pages)
- Current page: 55 of 155
- Download datasheet (920Kb)
This mode is selected in TDM TX Link Control (0x0600-0x060F) and TDM RX Link Control (0x0700-0x070F) by
the following settings.
4.2
In this mode, two or four links are logically OR’ed together to share a single stream. This is particularly useful for
fractional T1/E1 applications where links using different time slots can be multiplexed together onto a single stream
in order to facilitate the interface to a single T1 or E1 framer.
Links that are OR’ed together can have any one of the Single mode discussed in Section 4.1. To avoid any
contention, mapping registers of those links must not have the same bit set.
All links in Wire-OR mode must be configured in the same as they were in Single mode, except for TDM Link Control
registers. Two minor modes are available, 2-link grouping and 4-link grouping.
4.2.1
Two links in a pair are OR’ed together by using this mode. The links that are paired are pre-determined: link 0 is
paired with link 1, link 2 is paired with link 3 and so on. When link 0 and link 1 are paired, the pins associated with
link 1 cannot be used and are tri-stated, however, bit 7 of its TDM TX(RX) Link Control registers must be set. The
two links operate using the Clock and SYNC signals of link 0. The same logic applies for the other pairs.
This mode is selected in TDM TX Link Control (0x0600-0x060F) and TDM RX Link Control (0x0700-0x070F) by
the following settings. Note that both links in a pair must have the same settings.
4.2.2
Four links in a group are OR’ed together by using this mode. The links that are grouped are pre-determined: links 0,
1, 2 and 3 are grouped and the OR’ed input/output is available on link 0 only. Pins associated with links 1, 2 and 3
cannot be used and are tri-stated, however, bit 7 of TDM TX(RX) Link Control registers for those three links must
be set. The four links operate using the Clock and SYNC signal of link 0. The same logic applies for the other groups.
This mode is selected in TDM TX Link Control (0x0600-0x060F) and TDM RX Link Control (0x0700-0x070F) by
the following settings. Note that all four links in a group must have the same settings.
Wire-OR Mode
Data rate (bits 6:5) = 01
Multiplex mode (bits 4:3) = 00
Clock and Sync format (bit 2) = 1
Cell delineation mode (bit 10 of TDM RX Link Control only) = 0
Data rate (bits 6:5) = 00 or 01
Multiplex mode (bits 4:3) = 01
Clock and Sync format (bit 2) = 0 or 1
Enable (bit 7) = 1
Cell delineation mode (bit 10 of TDM RX Link Control only) = 0
Data rate (bits 6:5) = 00 or 01
Multiplex mode (bits 4:3) = 10
Clock and Sync format (bit 2) = 0 or 1
Enable (bit 7) = 1
Cell delineation mode (bit 10 of TDM RX Link Control only) = 0
Wire-OR Mode - 2 Link Grouping
Wire-OR Mode - 4 Link Grouping
Zarlink Semiconductor Inc.
MT90222/3/4
55
Data Sheet
Related parts for MT90222
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Zarlink Semiconductor Inc [TV IF PREAMPLIFIER]
Manufacturer:
Zarlink Semiconductor
Datasheet:
Part Number:
Description:
Satellite Channel Decoder
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Power Factor Controller
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
CMOS/SNOS NVSRAM HIGH PERFORMANCE 8 K x 8 NON-VOLATILE STATIC RAM
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Dual stage IF amplifier for cable tuners
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Synthesized Broadband Converter with Programmable Power
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Cable Tuner Front End LNA with AGC
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Front End Power Splitter with AGC
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
1.3GHz Dual Wideband Logarithmic Amplifier
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
Wide Dynamic Range Image Reject MOPLL
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND PLL FM DETECTOR FOR SATELLITE TV
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND LINEAR FM DETECTOR FOR SATELLITE TV
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND LOG IF STRIP AMPLIFIER
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
WIDEBAND LOG IF STRIP AMPLIFIER
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet:
Part Number:
Description:
THIS DOCUMENT IS FOR MAINTENANCE PURPOSES ONLY AND IS NOT RECOMMENDED FOR NEW DESIGNS
Manufacturer:
ZARLINK [Zarlink Semiconductor Inc]
Datasheet: