FDC37C669_07 SMSC [SMSC Corporation], FDC37C669_07 Datasheet - Page 29

• Manufacturer Part Number: FDC37C669_07
• Description: PC 98/99 Compliant Super I/O Floppy Disk Controller with Infrared Support
• Manufacturer: SMSC [SMSC Corporation]

MAIN STATUS REGISTER
Address 3F4 READ ONLY
The Main Status Register is a read-only register
and indicates the status of the disk controller.
The Main Status Register can be read at any
BIT 0 - 3 DRV x BUSY
These bits are set to 1s when a drive is in the
seek portion of a command, including implied
and overlapped seeks and recalibrates.
BIT 4 COMMAND BUSY
This bit is set to a 1 when a command is in
progress.
command byte has been accepted and goes
inactive at the end of the results phase. If there
is
commands), this bit is returned to a 0 after the
last command byte.
no
result
RQM
This bit will go active after the
7
phase
DIO
6
(Seek,
NON
DMA
5
Recalibrate
BUSY
CMD
4
29
BUSY
DRV3
time. The MSR indicates when the disk
controller is ready to receive data via the Data
Register. It should be read before each byte
transferring to or from the data register except in
DMA mode. NO delay is required when reading
the MSR after a data transfer.
BIT 5 NON-DMA
This
command and will be set to a 1 during the
execution phase of a command.
polled data transfers and helps differentiate
between the data transfer phase and the reading
of result bytes.
BIT 6 DIO
Indicates the direction of a data transfer once a
RQM is set.
indicates a write is required.
BIT 7 RQM
Indicates that the host can transfer data if set to
a 1. No access is permitted if set to a 0.
3
mode
DRV2
BUSY
2
is
A 1 indicates a read and a 0
selected
DRV1
BUSY
1
in
DRV0
BUSY
the
0
This is for
SPECIFY