dac1005d650 NXP Semiconductors, dac1005d650 Datasheet - Page 26

• Manufacturer Part Number: dac1005d650
• Description: Dual 10-bit Dac, Up To 650 Msps; 2? 4? And 8? Interpolating
• Manufacturer: NXP Semiconductors

NXP Semiconductors
DAC1005D650_1
Product data sheet
10.7.1 NCO in 32-bit
10.7.2 Low-power NCO
10.7.3 Minus 3 dB
10.7 Quadrature modulator and NCO
10.8 x / (sin x)
The quadrature modulator allows the 10-bit I and Q data to be mixed with the carrier
signal generated by the Numerically Controlled Oscillator (NCO).
The frequency of the NCO is programmed over 32-bit and allows the sign of the sine
component to be inverted in order to operate positive or negative, lower or upper single
sideband up-conversion.
When using the NCO, the frequency can be set by the four registers FREQNCO_LSB,
FREQNCO_LISB, FREQNCO_UISB and FREQNCO_MSB over 32 bits.
The frequency for the NCO in 32-bit is calculated as follows:
where M is the decimal representation of FREQ_NCO[31:0].
The phase of the NCO can be set from 0 to 360 by both registers PHINCO_LSB and
PHINCO_MSB over 16 bits.
The default setting is f
When using the low-power NCO, the frequency can be set by the 5 MSB of register
FREQNCO_MSB.
The frequency for the low-power NCO is calculated as follows:
where M is the decimal representation of FREQ_NCO[31:27].
The phase of the low-power NCO can be set by the 5 MSB of the register PHINCO_MSB.
During normal use, a full-scale pattern will also be full scale at the output of the DAC.
Nevertheless, when the I and Q data are simultaneously close to full scale, some clipping
can occur and the Minus_3dB function can be used to reduce gain by 3 dB in the
modulator. This is to keep a full-scale range at the output of the DAC without added
interferers.
Due to the roll-off effect of the DAC, a selectable FIR filter is inserted to compensate for
the (sin x) / x effect. This filter introduces a DC loss of 3.4 dB. The coefficients are
represented in
f
NCO
f
NCO
=
=
---------------- -
M
M
---------------- -
2
32
2
5
Table 34 “Inversion filter
f
s
f
s
NCO
Rev. 01 — 28 July 2009
Dual 10-bit DAC, up to 650 Msps; 2 4 and 8 interpolating
= 96 MHz when f
coefficients”.
s
= 640 Msps and the default phase is 0 .
DAC1005D650
© NXP B.V. 2009. All rights reserved.
26 of 41
(1)
(2)