WM8753 Wolfson Microelectronics plc, WM8753 Datasheet - Page 53

• Manufacturer Part Number: WM8753
• Description: HI FI AND TELEPHONY DUAL CODEC
• Manufacturer: Wolfson Microelectronics plc

WM8753L
DIGITAL AUDIO INTERFACES
w
The WM8753L has two audio interfaces – a hi-fi audio interface and a voice audio interface. The hi-fi
audio interface is used for the input of data to the hi-fi DAC and may also be used to output data from
the stereo voice ADC. The voice audio interface is used for the input of data to the voice DAC and for
output of data from the voice ADC.
HI-FI AUDIO INTERFACE
The Hi-Fi audio interface has four pins:
The clock signals BCLK, and LRC can be outputs when the WM8753L operates as a master, or
inputs when it is a slave (see Master and Salve Mode Operation, below).
Four different audio data formats are supported:
All four of these modes are MSB first. They are described in Audio Data Formats, below. Refer to the
Electrical Characteristic section for timing information.
VOICE AUDIO INTERFACE
The voice audio interface has four pins:
The clock signals VXCLK, and VXFS can be outputs when the WM8753L operates as a master, or
inputs when it is a slave (see Master and Slave Mode Operation, below). A mixed master/slave mode
is also supported where BCLK and VXCLK are outputs from the WM8753L but DACLRC, ADCLRC
and VXFS are inputs.
The same four audio modes are supported. The interface can also operate in mono mode where only
the left or right channel data is transferred. The DATASEL bits can be used to configure which of the
ADCs data is output.
MASTER AND SLAVE MODE OPERATION
The WM8753L audio interfaces may be individually configured as either master or slave interfaces.
As a master Hi-Fi interface device the WM8753L generates BCLK and LRC and thus controls
sequencing of the data transfer on ADCDAT and DACDAT. As a master voice interface device the
WM8753L generates VXCLK and VXFS and thus controls sequencing of the data transfer on VXDIN
and VXDOUT. In slave modes, the WM8753L responds with data to clocks it receives over the digital
audio interfaces. These modes can be selected by writing to the MS and PMS bits. With the interface
configured as a Master the LRC and VXFS outputs may be disabled and configured as inputs using
LRCOE and VXFSOE for an external frame sync from the controller to be input. In this mode the
generated LRC and VXFS must adhere to the timing requirements diagrams detailed in the Signal
Timing Requirements section on page 8. Master, slave and mixed modes are illustrated below.
ADCDAT: ADC data output
DACDAT: DAC data input
LRC: Data alignment clock
BCLK: Bit clock, for synchronisation
Left justified
Right justified
I
DSP mode
VXDOUT: voice ADC data output
VXDIN: voice DAC data input
VXFS: data alignment clock or frame sync
VXCLK: Bit clock, for synchronisation
2
S
AI Rev 3.1 June 2004
Advanced Information
53