GS1560A Gennum Corporation, GS1560A Datasheet - Page 54

• Manufacturer Part Number: GS1560A
• Description: Reclocking Deserializer For HD-SDI, Sd-sdi & Dvb-asi With Loop Thru Cable Driver. 3.3/1.8V Supply.
• Manufacturer: Gennum Corporation

5. REFERENCES & RELEVANT STANDARDS
5. REFERENCES & RELEVANT STANDARDS
5. REFERENCES & RELEVANT STANDARDS
5. REFERENCES & RELEVANT STANDARDS
SMPTE 125M
SMPTE 260M
SMPTE 267M
SMPTE 274M
SMPTE 291M
SMPTE 292M
SMPTE 293M
SMPTE 296M
SMPTE 352M
SMPTE RP165
SMPTE RP168
6. PACKAGE & ORDERING INFORMATION
6. PACKAGE & ORDERING INFORMATION
6. PACKAGE & ORDERING INFORMATION
6. PACKAGE & ORDERING INFORMATION
6.1 PACKAGE DIMENSIONS
6.1 PACKAGE DIMENSIONS
6.1 PACKAGE DIMENSIONS
6.1 PACKAGE DIMENSIONS
GENNUM CORPORATION
Component video signal 4:2:2 – bit parallel interface
1125 / 60 high definition production system – digital representation and bit parallel interface
Bit parallel digital interface – component video signal 4:2:2 16 x 9 aspect ratio
1920 x 1080 scanning analog and parallel digital interfaces for multiple picture rates
Ancillary Data Packet and Space Formatting
Bit-Serial Digital Interface for High-Definition Television Systems
720 x 483 active line at 59.94 Hz progressive scan production – digital representation
1280 x 720 scanning, analog and digital representation and analog interface
Video Payload Identification for Digital Television Interfaces
Error Detection Checkwords and Status Flags for Use in Bit-Serial Digital Interfaces for Television
Definition of Vertical Interval Switching Point for Synchronous Video Switching
NOTES:
Diagram shown is representative only. Table X is fixed for all pin sizes, and
Table Y is specific to the 80-pin package.
1. DIMENSIONS D1 AND E1 DO NOT INCLUDE MOLD PROTRUSION.
2. DIMENSION b DOES NOT INCLUDE DAMBAR PROTRUSION.
54 of 55
ALLOWABLE PROTRUSION IS 0.25mm PER SIDE. D1 AND E1 ARE
MAXIMUM PLASTIC BODY SIZE DIMENSIONS INCLUDING MOLD
MISMATCH.
ALLOWABLE DAMBAR PROTRUSION SHALL NOT CAUSE THE LEAD
WIDTH TO EXCEED THE MAXIMUM b DIMENSION BY MORE THAN
WIDTH TO EXCEED THE MAXIMUM b DIMENSION BY MORE THAN
0.08mm. DAMBAR CAN NOT BE LOCATED ON THE LOWER RADIUS
OR THE FOOT. MINIMUM SPACE BETWEEN PROTRUSION AND AN
ADJACENT LEAD IS 0.07mm FOR 0.4mm AND 0.5mm PITCH PACKAGES.
Table Y
S YM BO L
bbb
aaa
ccc
ddd
D2
E2
b
e
Table X
CONTROL DIMENSIONS ARE IN MILLIMETERS.
TOLERANCES OF FORM AND POSITION
0.2 2
MIN
MIL LIME TE R
0.65 BS C
N O M
12 .35
12 .35
0 .20
0 .20
0 .10
0.1 3
0 .30
M AX
0 .38 0 .009 0.0 12 0.01 5
80 L
MIN
0.0 26 BS C
0.4 86
0.4 86
0 .008
0 .008
0 .004
0 .005
NO M
INC H
M AX
27360-1