S1D13700F01 Epson Electronics America, Inc., S1D13700F01 Datasheet - Page 131

• Manufacturer Part Number: S1D13700F01
• Description: Embedded Memory Graphics Lcd Controller
• Manufacturer: Epson Electronics America, Inc.

Epson Research and Development
Vancouver Design Center
X42A-A-001-04
X42A-A-001-04
X42A-A-001-04
Hardware Functional Specification
Issue Date: 2005/12/13
• section 7.2, added new diagram and additional information to Note 1 about case when
• section 7.3.6, fixed description of DIV parameter, should be = OSC Divider (CNF[1:0])
• section 7.4, updated the Power Save Mode/Display Enable Timing diagram
• section 7.4, added the following note to Power Save Mode/Display Enable Timing
• section 20, updated Japan and Taiwan sales information
• section 5.4, fixed typos of pin names in Host Interface Pin Mapping table, “AB” should
• section 7.3, fixed typos of pin names in Host Interface Timing section, “AB” should be
• section 7.2, updated the reset timing section to clarify the “Oscillator stable delay” and
• section 7.3.6, added new section for Display Memory Access timing
• section 12.2.3, added reference to new section for Display Memory Access timing and
• section 5.4, updated the Host Interface Pin Mapping Table, AS# for the M6800 Indirect
• section 7.3.5, updated the M6800 Family Bus Indirect Interface Timing diagram to
• section 9.2.1, in system clock section, changed the 2 occurrences of “internal crystal”
• section 10.3.1, in the System Control Registers section, changed “'The SYSTEM SET
• section 10.3.1, in the Power Save Registers section, changed “'standby mode” to “power
Revision 4.04
Revision 4.03
Revision 4.02
internal oscillator is used with external crystal
and should be “4 or 8 or 16” instead of “2 or 4 or 8”
section, “When using an external crystal with the internal oscillator, a delay is required
after exiting power save mode for system stabilization. For further information, refer to
Section 7.2, “Reset Timing” on page 25.”
be “A” and “DB” should be “D”
“A” and “DB” should be “D”
“Reset pulse duration”
added note about text mode
mode is changed to “Connected to HIOVDD” instead of “Connected to VSS”
removed AS# and t13, t14, also removed t13, t14 from the timing table
with “internal oscillator (with external crystal)”
command is used to initialize the S1D13700F01 and the display when indirect
addressing is used.” to “The SYSTEM SET command is used to configure the
S1D13700F01 for the display used and to exit power save mode when indirect
addressing is used.”
save mode” and added the following note “The SYSTEM SET command is used to exit
power save mode, when indirect addressing is used. For further information on the
SYSTEM SET command, see section 11.1.1, “SYSTEM SET” on page 71.”
Revision 4.05
X42A-A-002-04
S1D13700F01
Page 131