XW2B-80J7-1A Omron, XW2B-80J7-1A Datasheet - Page 27

• Manufacturer Part Number: XW2B-80J7-1A
• Description: RELAY UNIT
• Manufacturer: Omron

Specifications of XW2B-80J7-1A

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2B80J71A

FQM1 Configuration
Pulse Input Frequency
Measurement Function
Wide Variety of Interrupt
Functions
High-speed Analog I/O
Supported
Writing and Monitoring
Ladder Programs
1-2
4
FQM1 Configuration
Power Supply Unit
CX-Programmer
Peripheral port
Note
Note
Coordinator Module
RS-232C port
The speed of pulse inputs can be measured at the same time as the number
of pulse inputs is counted.
The FQM1 can provide high-speed I/O responses because it has a wide vari-
ety of functions for starting interrupt tasks, in addition to input interrupts, inter-
val timer interrupts, high-speed counter interrupts, and pulse output interrupts.
Motion Control Modules with analog I/O support linear (displacement/length
measurement) sensor input, inverter control, and control of Servomotors with
analog-input Servo Drivers. This gives flexibility for a great variety of motion
applications.
The ladder program for each Module is written using CX-Programmer Ver.
5.01 or later (see note) and then written to each Module via the peripheral
port on the Coordinator Module.The ladder program is saved in each Module
and operation of the program can be monitored from the CX-Programmer.
FQM1 Patch Software must be installed for CX-Programmer Ver. 5.0.
The FQM1 consists of a Power Supply Unit, a Coordinator Module, one or
more Motion Control Modules, and an End Module. Motion Control Modules
are available with either pulse I/O or analog I/O and up to four Motion Control
Modules can be connected in one system. (See note.)
The number of Motion Control Modules with Analog I/O that can be connected
is limited by the output capacity of the Power Supply Unit.
Servo Relay Units
Servomotors/
Servo Drivers
Motion Control Modules
End Module
RS-422A
Section 1-2