MC68340AG16E Freescale Semiconductor, MC68340AG16E Datasheet - Page 108

• Manufacturer Part Number: MC68340AG16E
• Description: IC MPU 32BIT 16MHZ 144-LQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC68340AG16E

• Processor Type: M683xx 32-Bit
• Speed: 16MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 144-LQFP
• Controller Family/series: 68K
• Core Size: 32 Bit
• No. Of I/o's: 16
• Cpu Speed: 16MHz
• No. Of Timers: 2
• Embedded Interface Type: UART
• Digital Ic Case Style: LQFP
• Rohs Compliant: Yes
• Processor Series: M683xx
• Core: CPU32
• Maximum Clock Frequency: 16 MHz
• Maximum Operating Temperature: + 105 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Details

To use an external clock source (see Figure 4-6), the operating clock frequency can be
driven directly into the EXTAL pin (the XTAL pin must be left floating for this case). This
approach results in a system clock and CLKOUT that are the same as the input signal
frequency, but not tightly coupled to it. To enable this mode, MODCK must be held low
during reset, and V
Alternatively, an external clock signal can be directly driven into EXTAL (with XTAL left
floating) using the on-chip PLL. This configuration results in an internal clock and
CLKOUT signal of the same frequency as the input signal, with a tight skew between the
external clock and the internal clock and CLKOUT signals. To enable this mode, MODCK
must be held low during reset, and V
If an input signal loss for either of the clock modes utilizing the PLL occurs, chip operation
can continue in limp mode with the VCO running at approximately one-half the operating
speed (affected by the value of the X-bit in the SYNCR), using an internal voltage
reference. The SLIMP bit in the SYNCR indicates that a loss of input signal reference has
been detected. The RSTEN bit in the SYNCR controls whether an input signal loss causes
a system reset or causes the device to operate in limp mode. The SLOCK bit in the
SYNCR indicates when the VCO has locked onto the desired frequency or if an external
clock is being used.
4.2.3.1 PHASE COMPARATOR AND FILTER. The phase comparator takes the output of
the frequency divider and compares it to an external input signal reference. The result of
MOTOROLA
NOTES:
1. Must be low-leakage capacitor.
2. External mode uses this path only.
EXTAL
2
EXTERNAL
CLOCK
Figure 4-6. Clock Block Diagram for External Oscillator Operation
OSCILLATOR
CRYSTAL
CCSYN
XTAL
Freescale Semiconductor, Inc.
COMPARATOR
For More Information On This Product,
held at 0 V while the chip is in operation.
PHASE
MC68340 USER’S MANUAL
Go to: www.freescale.com
CCSYN
CLOCK CONTROL
XFC PIN
FEEDBACK
DIVIDER
should be connected to a quiet 5-V source.
LOW-PASS
FILTER
XFC
V CCSYN
1
V CCSYN
.01 µF
0.1 µF
VCO
SYSTEM
CLOCK
CLKOUT
4- 11