CVM1-PA208 Omron, CVM1-PA208 Datasheet - Page 121

• Manufacturer Part Number: CVM1-PA208
• Description: CV/CVM1 POWER SUPPLY, AC
• Manufacturer: Omron

Specifications of CVM1-PA208

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

5-4-2 Replacing a CPU Battery
Replacing a CPU Unit
!
Caution
When the battery is nearly discharged, the ALARM indicator will blink, bit
A42615 will turn ON, and the message “BATT LOW” will appear on the Program-
ming Device. In duplex mode, bit A42613 will turn ON when the battery is low in
the active CPU Unit, and bit A42611 will turn ON if it is low in the standby CPU
Unit.
When this occurs, replace the battery within one week to avoid loss of data. The
battery and connector are provided as a set. To replace the Battery Set, follow
the steps below. The entire replacement must be completed within five minutes
to ensure that the data will not be lost.
Do not short circuit, charge, disassemble, or expose the battery to heat. The bat-
tery fluid is flammable and if mishandled, may cause a fire or explosion. Do not
incinerate the battery after use.
After setting the CPU usage switch to CPU USE, wait at least three seconds
before pressing the Initialize Button. The CPU’s internal processing takes
approximately three seconds after the switch is set to CPU USE, so the Ini-
tialize Button will not be effective during that interval.
Section
105
5-4