CVM1-PA208 Omron, CVM1-PA208 Datasheet - Page 105

• Manufacturer Part Number: CVM1-PA208
• Description: CV/CVM1 POWER SUPPLY, AC
• Manufacturer: Omron

Specifications of CVM1-PA208

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Turning ON the Power
Setting Expansion Rack
Numbers
Creating an I/O Table
4-4
Preparations for Trial Operation
Preparations for Trial Operation
1, 2, 3...
Note Use version 2.0 or later for the CVM1D.
The indicators will be as shown in the “Power ON” column on page 93 right after
the power is turned ON.
When the CPU Unit and Duplex Unit settings have been completed, refer to 4-4
Preparations for Trial Operation.
Set the rack numbers (No. 1 to 7) for the Expansion Racks using the I/O Interface
Unit on each Rack.
• Refer to the CVM1D Duplex System Operation Manual (W351) for details on
• Make sure not to use the same number twice.
The rack number set when the power is turned ON remains in effect until the
power is turned OFF and then ON again.
Create an I/O table after completing wiring, switch settings, and connection of
Programming Devices, such as the Programming Console or SYSMAC Support
Software.
Mount all the I/O Units, Special I/O Units, and CPU Bus Units to be used. Turn
ON the power with the START INPUT left open and then set to PROGRAM mode
using a Programming Device, such as a Programming Console.
The following procedure is a brief description of how an I/O table is created using
the Programming Console. For details, refer to CVM1-PRS21-EV1 Program-
ming Console Operation Manual (W222) and other applicable manuals.
11. Connect a Programming Device, such as a Programming Console or the
1. Connect the Programming Console, set the PROGRAM mode, and then
word allocations.
SYSMAC Support Software, to the PERIPHERAL connector.
turn ON the power supply.
Screen display when the power is turned ON
CVM1-PRS21-V1 20
Mon time:10sec
Message #: 0
Read Setup Yes
Section
4-4
89