QB-MINI2-EE NEC, QB-MINI2-EE Datasheet - Page 14

• Manufacturer Part Number: QB-MINI2-EE
• Description: EMULATOR, PROGRAMMER, MINICUBE2
• Manufacturer: NEC
• Type: Debug Emulatorr

Specifications of QB-MINI2-EE

• Svhc: No SVHC (18-Jun-2010)
• Mcu Supported Families: MINICUBE2
• Silicon Family Name: V850, 78K0R, 78K0S
• Ic Product Type: On-Chip Debug Emulator
• Kit Contents: MINICUBE2, USB Cable, Target Cable, 78K0-OCD Board
• Features: On-Chip Debugging, Flash Memory Programming,

2.2
14
(1) Mode select switch
(2) Power select switch
Figure 2-2 shows the part names of the MINICUBE2 main unit. For their functions, refer to (1) to (5) below.
Part Names and Functions of MINICUBE2
This switch is used to select the target device. Table 2-1 describes the setting details. This switch is set to
″M2″ at shipment.
This switch is used to set the power supplied to the target system. Table 2-2 describes the setting details.
This switch is set to ″3″ at shipment.
Caution Do not change the switch setting while the USB cable is connected.
Note
Target interface
Target interface
connector
connector
3
5
T
M1
M2
Setting
Setting
The maximum rating of the current is 100mA, so do not use MINICUBE2 with the target system with
the higher current rating.
machine.
Mode select switch
Mode select switch
Sets 78K0S or 78K0R microcontroller as target device
Sets V850 or 78K0 microcontroller as target device (factory setting)
3 V is supplied from MINICUBE2 to the target system
The supplied power is fed back to MINICUBE2 and used only for power detection.
5 V is supplied from MINICUBE2 to the target system
The supplied power is fed back to MINICUBE2 and used only for power detection.
Power supply of the target system is used.
MINICUBE2 only detects the power for the target system.
CHAPTER 2
Table 2-1. Description of Mode Select Switch
Mode LED
Mode LED
Table 2-2. Setting of Power Select Switch
Figure 2-2. Part Names of MINICUBE2
The power is always supplied after MINICUBE2 is connected to the host
User’s Manual U18371EJ1V0UM
NAMES AND FUNCTIONS OF HARDWARE
Description
Description
Note
Note
. (Factory setting)
.
Power select switch
Power select switch
USB interface
USB interface
connector
connector