SPBT2532C2.AT STMicroelectronics, SPBT2532C2.AT Datasheet - Page 39

• Manufacturer Part Number: SPBT2532C2.AT
• Description: IC BLUETOOTH VER 2.1 CLASS 2
• Manufacturer: STMicroelectronics

Specifications of SPBT2532C2.AT

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, Class 2 & 3
• Applications: General Purpose
• Power - Output: 2dBm
• Sensitivity: -85dBm
• Voltage - Supply: 2.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 48kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2400 MHz to 2483.5 MHz
• Interface Type: I2C, I2S, SPI, UART
• Data Rate: 2 Mbps
• Modulation: AFH
• Operating Voltage: 2.8 V to 3.6 V
• Antenna: Without Antenna
• Board Size: 10 mm x 13 mm
• Operating Temperature Range: - 40 C to + 85 C
• Output Power: 4 mA
• Security: 128 bit Encryption
• Technology/ Type: Class 2 Bluetooth Module
• Processor Series: STLC2500
• For Use With: 497-10656 - BOARD DEMO BLUETOOTH SPBT2532C2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Bluetooth Devices
• Other names: 497-10539

SPBT2532C2.AT
D.29
D.29.1
D.29.2
D.29.3
D.30
D.30.1
D.30.2
StreamingSerial
The StreamingSerial command is used to enable/disable the UART flow control.
Syntax
AT+AB StreamingSerial [Enable/Disable]
Where [Enable/Disable] is an e or E character to enable this parameter and a d or D
character to disable it. StreamingSerial command will disable RTS/CTS hardware flow
control and discard non-transmitted data when enabled. RTS/CTS flow control is enabled,
when StreamingSerial is disabled.
Query
An alternative syntax may be used to query the current StreamingSerial feature status. This
syntax is not supported by other commands.
AT+AB StreamingSerial
Responses
If the feature is successfully applied or queried, the response is:
AT-AB StreamingSerial [Enabled/Disabled]
UpdateInquiryScan
The UpdateInquiryScan command is used to modify the Inquiry scan parameters: mode,
duration, and interval.
Syntax
AT+AB UpdateInquiryScan [mode] [duration] [interval]
where[mode] is the discoverable mode:
●
●
●
[duration] is the scan length in slots; 18 to 4096. The default duration is 18 slots.
[interval] is the period between scans in slots; 18 to 4096. The default interval is 2048
slots
Responses
If the command is successful, the response is:
AT-AB InquiryScanUpdateDone
0: non-discoverable
1: limited discoverability – not supported
2: discoverable
Doc ID 16089 Rev 7
Command description
39/50