SPBT2532C2.AT STMicroelectronics, SPBT2532C2.AT Datasheet - Page 36

• Manufacturer Part Number: SPBT2532C2.AT
• Description: IC BLUETOOTH VER 2.1 CLASS 2
• Manufacturer: STMicroelectronics

Specifications of SPBT2532C2.AT

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, Class 2 & 3
• Applications: General Purpose
• Power - Output: 2dBm
• Sensitivity: -85dBm
• Voltage - Supply: 2.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 48kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2400 MHz to 2483.5 MHz
• Interface Type: I2C, I2S, SPI, UART
• Data Rate: 2 Mbps
• Modulation: AFH
• Operating Voltage: 2.8 V to 3.6 V
• Antenna: Without Antenna
• Board Size: 10 mm x 13 mm
• Operating Temperature Range: - 40 C to + 85 C
• Output Power: 4 mA
• Security: 128 bit Encryption
• Technology/ Type: Class 2 Bluetooth Module
• Processor Series: STLC2500
• For Use With: 497-10656 - BOARD DEMO BLUETOOTH SPBT2532C2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Bluetooth Devices
• Other names: 497-10539

Command description
D.20.2
D.21
D.21.1
D.21.2
D.22
D.22.1
D.22.2
D.23
D.23.1
36/50
Responses
If the operation is successful, the response is:
AT-AB LocalNameOk
PortDisconnect
The PortDisconnect command is used to terminate a connection with the remote device port
handle
Syntax
AT+AB PortDisconnect
Responses
If the operation is successful, the response is:
AT+AB ConnectionDown
Reset
The Reset command is used to reset the abSerial interface. This is provided in the event
that a host application wants to perform a software reset for error recovery. There is a
response prior to reset to verify the command was received by the abSerial interface.
Reset operation requires 1.6 seconds.
Syntax
AT+AB Reset
Responses
If the operation is successful, the response is:
AT-AB ResetPending
RoleSwitch
The RoleSwitch command is used to change a link from/to a Master or Slave role
Syntax
AT+AB RoleSwitch [BD address] [role]
Where
[Bd address] is the address of the remote device that will receive the role switch
[role] is the new role of the local device: 0 = Master, 1 = Slave.
Doc ID 16089 Rev 7
SPBT2532C2.AT