SPBT2532C2.AT STMicroelectronics, SPBT2532C2.AT Datasheet - Page 33

• Manufacturer Part Number: SPBT2532C2.AT
• Description: IC BLUETOOTH VER 2.1 CLASS 2
• Manufacturer: STMicroelectronics

Specifications of SPBT2532C2.AT

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, Class 2 & 3
• Applications: General Purpose
• Power - Output: 2dBm
• Sensitivity: -85dBm
• Voltage - Supply: 2.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 48kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2400 MHz to 2483.5 MHz
• Interface Type: I2C, I2S, SPI, UART
• Data Rate: 2 Mbps
• Modulation: AFH
• Operating Voltage: 2.8 V to 3.6 V
• Antenna: Without Antenna
• Board Size: 10 mm x 13 mm
• Operating Temperature Range: - 40 C to + 85 C
• Output Power: 4 mA
• Security: 128 bit Encryption
• Technology/ Type: Class 2 Bluetooth Module
• Processor Series: STLC2500
• For Use With: 497-10656 - BOARD DEMO BLUETOOTH SPBT2532C2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Bluetooth Devices
• Other names: 497-10539

SPBT2532C2.AT
D.12.2
D.13
D.13.1
D.13.2
D.14
D.14.1
D.14.2
Responses
If the operation is successful, the response is:
AT-AB BondEnabled
If bonding has been initiated by a remote device, the notification is:
AT-AB BondPending [BD addr]
where [BD addr] is the BD address of the remote device that initiated the bonding.
If bonding has occurred, the notification is:
AT-AB BondOk [BD addr]
where [BD addr] is the BD address of the remote device with successful bonding.
If bonding was initiated by a remote device but failed, the notification is
AT-AB BondFail
When the time limit for bonding has expired, the notification is
AT-AB BondDisabled
EraseBondTable
The EraseBondTable command is used to erase all of the bonded device entries. Single
devices cannot be erased with this command
Syntax
AT+AB EraseBondTable
Responses
If the operation is successful, the response is:
AT-AB BondTableErased
GetBDAddress
The GetBDAddress command is used to read the local device’s Bluetooth Device Address
or MAC address.
Syntax
AT+AB GetBDAddress
Responses
If the operation is successful, the response is:
AT-AB BD_ADDR = [BD address]
Doc ID 16089 Rev 7
Command description
33/50