SPBT2532C2.AT STMicroelectronics, SPBT2532C2.AT Datasheet - Page 27

• Manufacturer Part Number: SPBT2532C2.AT
• Description: IC BLUETOOTH VER 2.1 CLASS 2
• Manufacturer: STMicroelectronics

Specifications of SPBT2532C2.AT

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, Class 2 & 3
• Applications: General Purpose
• Power - Output: 2dBm
• Sensitivity: -85dBm
• Voltage - Supply: 2.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 48kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2400 MHz to 2483.5 MHz
• Interface Type: I2C, I2S, SPI, UART
• Data Rate: 2 Mbps
• Modulation: AFH
• Operating Voltage: 2.8 V to 3.6 V
• Antenna: Without Antenna
• Board Size: 10 mm x 13 mm
• Operating Temperature Range: - 40 C to + 85 C
• Output Power: 4 mA
• Security: 128 bit Encryption
• Technology/ Type: Class 2 Bluetooth Module
• Processor Series: STLC2500
• For Use With: 497-10656 - BOARD DEMO BLUETOOTH SPBT2532C2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Bluetooth Devices
• Other names: 497-10539

SPBT2532C2.AT
Appendix D
D.1
D.1.1
D.1.2
D.2
D.2.1
D.3
The following subsections describe each of these commands in detail, including a
description of behavior, syntax (including possible parameter values), and types of
responses.
Some responses will not be “immediate”. Where applicable, these will be noted and will
include an approximate delay before response.
For commands with optional parameters, all possible forms will be listed under the syntax
subsection.
Error responses are described in
Bond
The Bond command is used to initiate bonding with a specified device. A personal
identification number (PIN) is also required with this command.
Syntax
AT+AB Bond [BD addr] [PIN]
Where [BD addr] is the BD Address of the remote device with which to bond and [PIN]
is the PIN code to use (up to 16 characters).
Responses
If the request is successfully submitted, the response is:
AT-AB BondPending [BD addr]
If the operation is successful, the response is:
AT-AB BondOk
If the operation fails, the response is:
AT-AB BondFail
BtcVersion
The Version command is used to return the current ID of the Bluetooth controller chip.
Syntax
AT+AB BtcVersion
Build
The Version command is used to return the current build ID of the application firmware.
Command description
Doc ID 16089 Rev 7
Appendix E
error responses.
Command description
27/50