PIC17C756-16/SP Microchip Technology, PIC17C756-16/SP Datasheet - Page 71

• Manufacturer Part Number: PIC17C756-16/SP
• Description: MICRO CTRL 16K MEMORY OTP 64SDIP
• Manufacturer: Microchip Technology
• Series: PIC® 17Cr

Specifications of PIC17C756-16/SP

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 50
• Program Memory Size: 32KB (16K x 16)
• Program Memory Type: OTP
• Ram Size: 902 x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 6 V
• Data Converters: A/D 12x10b
• Oscillator Type: External
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 64-SDIP (0.750", 19.05mm)
• Lead Free Status / RoHS Status: Request inventory verification / Request inventory verification
• Eeprom Size: -
• Other names: PIC17C756-16/P

10.0
PIC17C75X devices have seven I/O ports, PORTA
through PORTG. PIC17C76X devices have nine I/O
ports, PORTA through PORTJ. PORTB through
PORTJ have a corresponding Data Direction Register
(DDR), which is used to configure the port pins as
inputs or outputs. Some of these ports pins are multi-
plexed with alternate functions.
PORTC, PORTD, and PORTE are multiplexed with the
system bus. These pins are configured as the system
bus when the device’s configuration bits are selected to
Microprocessor or Extended Microcontroller modes. In
the two other microcontroller modes, these pins are
general purpose I/O.
PORTA, PORTB, PORTE<3>, PORTF, PORTG and
the upper four bits of PORTH are multiplexed with the
peripheral features of the device. These peripheral fea-
tures are:
• Timer Modules
• Capture Modules
• PWM Modules
• USART/SCI Modules
• SSP Module
• A/D Module
• External Interrupt pin
2000 Microchip Technology Inc.
I/O PORTS
When some of these peripheral modules are turned on,
the port pin will automatically configure to the alternate
function. The modules that do this are:
• PWM Module
• SSP Module
• USART/SCI Module
When a pin is automatically configured as an output by
a peripheral module, the pins data direction (DDR) bit
is unknown. After disabling the peripheral module, the
user should re-initialize the DDR bit to the desired con-
figuration.
The other peripheral modules (which require an input)
must have their data direction bits configured appropri-
ately.
When the device enters the “RESET state”, the Data
Direction registers (DDR) are forced set, which will
make the I/O hi-impedance inputs. The RESET state of
some peripheral modules may force the I/O to other
operations, such as analog inputs or the system bus.
Note:
A pin that is a peripheral input, can be con-
figured as an output (DDRx<y> is cleared).
The peripheral events will be determined
by the action output on the port pin.
PIC17C7XX
DS30289B-page 71