DF2210CUNP24V Renesas Electronics America, DF2210CUNP24V Datasheet - Page 139

• Manufacturer Part Number: DF2210CUNP24V
• Description: MCU 16BIT FLASH 3V 32K 64-QFN
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2210CUNP24V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: SCI, SmartCard, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 37
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

4.3
A reset has the highest exception priority.
When the RES or MRES* pin goes low, all processing halts and this LSI enters the reset state. To
ensure that this LSI is reset, hold the RES pin low for at least 20 ms at power-up or hold the RES
or MRES* pin low for at least 20 states during operation.
A reset initializes the internal state of the CPU and the registers of on-chip peripheral modules.
This LSI can also be reset by overflow of the watchdog timer. For details, see section 10,
Watchdog Timer (WDT).
Immediately after a reset, interrupt control mode 0 is set.
Notes: TRST in the HD64F2218, HD64F2218U, HD64F2218CU and HD64F2217CU, which
4.3.1
A reset can be of either of two types for the H8S/2218 Group: a power-on reset or a manual reset.
A reset for the H8S/2212 Group is power-on reset. Reset types are shown in table 4.3. A power-on
reset should be used when powering on.
The internal state of the CPU is initialized by either type of reset. A power-on reset also initializes
all the registers in the on-chip peripheral modules, while a manual reset initializes all the registers
in the on-chip peripheral modules except for the bus controller and I/O ports, which retain their
previous states.
With a manual reset, since the on-chip peripheral modules are initialized, ports used as on-chip
peripheral module I/O pins are switched to I/O ports controlled by DDR and DR.
* Supported only by the H8S/2218 Group.
incorporate a boundary scan function, should be brought low when power is on. For
details, see section 13, Boundary Scan Function.
Reset
Reset Types
Rev.7.00 Dec. 24, 2008 Page 83 of 698
REJ09B0074-0700