HD64F3672FPIV Renesas Electronics America, HD64F3672FPIV Datasheet - Page 76

• Manufacturer Part Number: HD64F3672FPIV
• Description: MCU 3/5V 16K I-TEMP PB-FREE 64-L
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3672FPIV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SCI
• Peripherals: PWM, WDT
• Number Of I /o: 26
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• For Use With: R0K436079S000BE - KIT DEV FOR H8/36079 W/COMPILER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 3 Exception Handling
When an on-chip peripheral module requests an interrupt, the corresponding interrupt request
status flag is set to 1, requesting the CPU of an interrupt. When this interrupt is accepted, the I bit
is set to 1 in CCR. These interrupts can be masked by writing 0 to clear the corresponding enable
bit.
3.4.3
Interrupts are controlled by an interrupt controller.
Interrupt operation is described as follows.
1. If an interrupt occurs while the NMI or interrupt enable bit is set to 1, an interrupt request
2. When multiple interrupt requests are generated, the interrupt controller requests to the CPU for
3. The CPU accepts the NMI or address break without depending on the I bit value. Other
4. If the CPU accepts the interrupt after processing of the current instruction is completed,
5. Then, the I bit of CCR is set to 1, masking further interrupts excluding the NMI and address
6. Next, the CPU generates the vector address corresponding to the accepted interrupt, and
Figure 3.3 shows a typical interrupt sequence where the program area is in the on-chip ROM and
the stack area is in the on-chip RAM.
Rev.4.00 Nov. 02, 2005 Page 50 of 304
REJ09B0143-0400
signal is sent to the interrupt controller.
the interrupt handling with the highest priority at that time according to table 3.1. Other
interrupt requests are held pending.
interrupt requests are accepted, if the I bit is cleared to 0 in CCR; if the I bit is set to 1, the
interrupt request is held pending.
interrupt exception handling will begin. First, both PC and CCR are pushed onto the stack. The
state of the stack at this time is shown in figure 3.2. The PC value pushed onto the stack is the
address of the first instruction to be executed upon return from interrupt handling.
break. Upon return from interrupt handling, the values of I bit and other bits in CCR will be
restored and returned to the values prior to the start of interrupt exception handling.
transfers the address to PC as a start address of the interrupt handling-routine. Then a program
starts executing from the address indicated in PC.
Interrupt Handling Sequence