LP1072 FREESCALE [Freescale Semiconductor, Inc], LP1072 Datasheet - Page 5

• Manufacturer Part Number: LP1072
• Description: 802.11a/b/g Baseband System Solution
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

3.1.1
The UART is used for testing and diagnostic purposes and is capable of supporting data transfer rates of
up to 115.2 kbps.
3.1.2
TBA
3.1.3
The LP1072 supports an external serial EEPROM for storing the boot loader, MAC address, calibration
data and any other vendor-specific data. The LP1072 supports serial EEPROMs of sizes from 8 Kbit
(organized as 1024 entries of 8 bits each, or 1024 x 8) up to 512 Kbit (organized as 65,536 x 8). Serial
EEPROMs from the following vendors have been tested and verified to work with the LP1072:
The EEPROM is supported through GPIOs. There is no dedicated hardware to support either I
serial EEPROMs.
The operating frequency of the serial EEPROM port is 400 kHz with a supply voltage of 3.0 V.
3.1.4
To support vendor-specific needs, the LP1072 provides eight bi-directional General Purpose Input Output
(GPIO) pins. Each pin can be independently configured as an input, output or an interrupt source. On reset,
the GPIOs default as inputs, i.e. output drivers enables will be inactive.
3.1.5
This block contains all the reset logic for both CPUs contained in the BRC and chip-wide reset control. It
also defines controls for memory address re-mapping.
3.1.6
TBA
3.1.7
TBA
Freescale Semiconductor
•
•
•
•
•
ATMEL (http:/www.atmel.com)
ST Microelectronics (http://www.st.com)
Microchip Technology (http://www.microchip.com)
Catalyst Semiconductor (http://www.catsemi.com)
Integrated Silicon Solutions, Inc. (http://www.issi.com)
UART
JTAG
Serial EEPROM Interface
GPIO
RMB Registers
Watchdog
Interrupt Controller
LP1072 Advance Information, Rev. 0.3
PRELIMINARY
Functional Description
2
C or SPI
5