LP1072 FREESCALE [Freescale Semiconductor, Inc], LP1072 Datasheet - Page 15

• Manufacturer Part Number: LP1072
• Description: 802.11a/b/g Baseband System Solution
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

4.2
The LP1072 supports CF+ and Compact Flash Specification Revision 2.0. The LP1072 CF host interface
supports both the I/O and storage modes of the Compact Flash Specifications. The interface allows an
external host (or an host DMA) to have 8-bit or 16-bit memory and I/O mode access to the device
according to the Compact Flash Specification 2.0.
4.3
The SRAM emulation mode provides an alternative write/read access to the device without using the CF
port (or SDIO) using generic SRAM access cycles. It supports 16-bit memory interface.
This mode is host-dependent and can be enabled and tested for a specific host.
4.4
4.4.1
Freescale Semiconductor
8 Kbyte Internal Memory Buffer RAM (offset 0x4000 to 0x5FFF)
Bit
7:0
•
1. RF_SIF_0_SCLK (serial clock)
2. RF_SIF_1_CS_N (chip select)
3. RF_SIF_2_DIN (data input)
•
•
•
•
•
•
•
The SPI is composed of 3 signals:
The serial information is sent to the RF transceiver in 18 bit bursts framed by chip select. The 18
bits comprises of leading 14 (or less) data bits and trailing 4 address bits
Programming clock edges are ignored until chip select goes active low.
All bits are shifted in on the rising edge of the clock and latched in when chip select returns inactive
high. (permissible for the clock in either state)
The interface can be programmed in any operating mode.
Serial information is clocked in with the most significant bit (MSB) first.
The address bits for the internal registers are decoded on the rising edge of chip select.
The rising edge of chip select initiates an internal parallel load pulse that latches the last 18-bit
serially shifted-in data into the internal register.
Imem_rdat[15:0]
CompactFlash+ Host Interface
SRAM Emulation Mode
RF Interface
Serial Programmable Interface (SPI)
Name
Table 8. SDIO Function 1 Registers (continued)
This is an internal memory buffer for specific use
by the SDIO device. Data is read or written to this
memory via SDIO cmd 53 reads or writes. Then,
the SDIO DMA controller is used to move the data
from the internal memory buffer to/from shared
memory under device (ARM) control.
LP1072 Advance Information, Rev. 0.3
PRELIMINARY
Description
Access
ARM
-⎯
Access
HOST
RW
LP1072 Interfaces
Reset
-⎯
15