KSZ8895MQ_12 MICREL [Micrel Semiconductor], KSZ8895MQ_12 Datasheet - Page 52

• Manufacturer Part Number: KSZ8895MQ_12
• Description: Integrated 5-Port 10/100 Managed Ethernet Switch with MII/RMII interface
• Manufacturer: MICREL [Micrel Semiconductor]

Micrel, Inc.
KSZ8895MQ/RQ/FMQ
SMI register Read access is selected when OP Code is set to “10” and bits [2:1] of the PHY address is set to ‘11’.
The 8-bit register address is the concatenation of {PHY address bits [4:3], PHY address bits [0], REG address bit
[4:0]}. TA is turn-around bits. TA bits [1:0] are ’Z0’ means the processor MDIO pin is changed to input Hi-Z from
output mode and the followed ‘0’ is the read response from device, as the switch configuration registers are 8-bit
wide, only the lower 8 bits of data bits [15:0] are used
SMI register Write access is selected when OP Code is set to “01” and bits [2:1] of the PHY address is set to ‘11’.
The 8-bit register address is the concatenation of {PHY address bits [4:3], PHY address bits [0], REG address bit
[4:0]}. TA bits [1:0] are set to ’10’, as the switch configuration registers are 8-bit wide, only the lower 8 bits of data bits
[15:0] are used.
To access the KSZ8895MQ/RQ/FMQ registers 0-255 (0x00 - 0xFF), the following applies:
PHYAD [4, 3, 0] and REGAD [4:0] are concatenated to form the 8-bit address; that is, {PHYAD [4, 3, 0], REGAD
[4:0]} = bits [7:0] of the 8-bit address.
Registers are 8 data bits wide. For read operation, data bits [15:8] are read back as zeroes. For write operation, data
bits [15:8] are not defined, and hence can be set to either zeroes or ones.
SMI register access is the same as the MIIM register access, except for the register access requirements presented
in this section.
52
March 2012
M9999-032612-1.5