s71jl064ha0bfw62 Advanced Micro Devices, s71jl064ha0bfw62 Datasheet - Page 64

• Manufacturer Part Number: s71jl064ha0bfw62
• Description: Stacked Multi-chip Product Mcp Flash Memory And Psram Cmos 3.0volt-only, Simultaneous Operation Flash Memories And Static Ram/pseudo-static Ram
• Manufacturer: Advanced Micro Devices

Notes:
1. See
2. See the section on DQ3 for information on the sector erase timer.
64
Table 11
Erase Suspend/Erase Resume Commands
The Erase Suspend command, B0h, allows the system to interrupt a sector erase
operation and then read data from, or program data to, any sector not selected
for erasure. The bank address is required when writing this command. This com-
mand is valid only during the sector erase operation, including the 80 µs time-out
period during the sector erase command sequence. The Erase Suspend command
is ignored if written during the chip erase operation or Embedded Program
algorithm. The bank address must contain one of the sectors currently selected
for erase.
When the Erase Suspend command is written during the sector erase operation,
the device requires a maximum of 20 µs to suspend the erase operation. How-
ever, when the Erase Suspend command is written during the sector erase
time-out, the device immediately terminates the time-out period and suspends
the erase operation.
After the erase operation has been suspended, the bank enters the erase-sus-
pend-read mode. The system can read data from or program data to any sector
not selected for erasure. (The device “erase suspends” all sectors selected for
erasure.) Reading at any address within erase-suspended sectors produces sta-
tus information on DQ7–DQ0. The system can use DQ7, or DQ6 and DQ2
together, to determine if a sector is actively erasing or is erase-suspended. Refer
to the
bits.
After an erase-suspended program operation is complete, the bank returns to the
erase-suspend-read mode. The system can determine the status of the program
for erase command sequence.
"Write Operation
No
Status" section section for information on these status
Figure 5. Erase Operation
Command Sequence
Data Poll to Erasing
Erasure Completed
Bank from System
Write Erase
(Notes 1, 2)
Data = FFh?
START
S29JL064H
P r e l i m i n a r y
Yes
Embedded
Erase
algorithm
in progress
S71JLxxxHxx_00A1 February 25, 2004