tmp89fm42a TOSHIBA Semiconductor CORPORATION, tmp89fm42a Datasheet - Page 408

• Manufacturer Part Number: tmp89fm42a
• Description: 8 Bit Microcontroller
• Manufacturer: TOSHIBA Semiconductor CORPORATION

RA000
Figure 23-1 How the On-chip Debug Emulator RTE870/C1 Is Connected to a Target System
23.3
23.4
system.
IBA provides a connector for this interface control cable as an accessory tool. Mounting this connector on a target
system will make it easier to use the on-chip debug function.
illegal memory access attempted by a third person: a password function and a Security Program function. If a password
is set on the TMP89FM42A, it is necessary to authenticate the password for using the on-chip debug function. By
setting both a password and the Security Program on the TMP89FM42A, it is possible to prohibit the use of all on-
chip debug functions. Furthermore, by using the option code, the on-chip debug function only can be used even if the
Security Program is enabled. However, to use the on-chip debug function in this setting, a password authentication
process is required.
Mode".
TMP89FM42A
Note 1: Ports P20 and P21 are used as communication control pins of the on-chip debug function. If the on-chip debug emulator
Note 2: If the reset control circuit on an application board affects the control of the on-chip debug function, it must be disconnected
Note 3: The power supply voltage VDD must be provided by a target system. The VDD pin is connected to the emulator so that
To use the on-chip debug function, the specific pins on a target system must be connected to an external debugging
The on-chip debug emulator RTE870/C1 can be connected to a target system via an interface control cable. TOSH-
The connection between the on-chip debug emulator RTE870/C1 and a target system is shown in Figure 23-1.
The TMP89FM42A provides two security functions to prevent the on-chip debug function from being used through
For information on how to set a password and to enable the read protection and option code, refer to "Serial PROM
How to Connect the On-chip Debug Emulator to a Target System
Security
OCDCK (P20)
OCDIO (P21)
RTE870/C1 is used, therefore, the port functions and the functions of UART0 and SIO0, which are also used as ports,
cannot be debugged. If the emulator is disconnected to be used as a single MCU, the functions of ports P20 and P21 can
be used. To use the on-chip debug function, however, P20 and P21 should be disconnected using a jumper, switch, etc.
if there is the possibility of other parts affecting the communication control.
using a jumper, switch, etc.
the level of voltage appropriate for driving communication pins can be obtained by using the power supply of a target
system. The connection of the VDD pin is for receiving the power supply voltage, not for supplying it from the emulator
side to a target system.
RESET
MODE
XOUT
VDD
VSS
XIN
Target system
VDD
During on-chip debugging
(Note 1)
(Note 3)
Other
parts
MCU mode
(Note 3)
(Note 2)
RESET
control
Level Shifter
(provided power supply by target system)
control cable
Connectors
Interface
Page 389
On-chip debug
RTE870/C1
emulator
Control Circuit
(provided power supply by bus power)
PC (host system)
TMP89FM42A
USB connection