C60K-CDR-A Omron, C60K-CDR-A Datasheet - Page 224

• Manufacturer Part Number: C60K-CDR-A
• Description: PROGRAMMABLE CONTROLLER CPU
• Manufacturer: Omron

Specifications of C60K-CDR-A

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
The following table outlines the changes made to the manual during each revision. Page numbers refer to the
previous version.
Revision
code
4A
4B
2
3
4
5
December 1994
March 1990
May 1989
May 1992
May 1993
July 1999
Date
Cat. No. W146-E1-5
Complete rewrite
IR area portion of Section 3 completely rewritten.
Corrections made to content on the following pages: 2, 6, 7, 11, 12, 18, 36–39, 42,
A Glossary has been added.
Sections 7–1 through 7–4 have been incorporated into Section 4 and mnemonic code
has been added throughout the manual for better clarity.
Terms changed: Normal condition to normally open condition and inverse condition to
normally closed condition.
Instruction names placed in all-caps.
Page 6: Data Access Console added. LSS/FIT interfacing requirements corrected.
Page 14: Data structure description corrected.
Page 15: Decimal point description corrected.
Page 17, 18: Accessible bits corrected.
Page 19: Number of connectable Units corrected.
Page 38: Jump description clarified.
Page 61: SV range changed. Accuracy figure removed.
Section 5–18: Control bits changed to be consecutive within each program.
Last graphic in last example in logic-block instruction description: LD 0500 changed to
OR 0500 and LD 0002 changed to AND 0002.
Section 5–11–2: Set value range changed from 00.00 and 99.99 to 00.02 and 99.99.
Explanation also added.
Page 109: Operand 1101 was changed to 1003 in the diagram.
Page 116: Values within the top table have been changed.
Pages 117, 118: Values on this page have been changed.
Pages 178 through 181: Information relating to the standards has changed.
Scan time changed to cycle time throughout the manual.
Pages 14 and 15: Accessible bits corrected.
Page 16: Table of numbers of I/O points for various system configurations added.
Page 20: Control bits related to counter instructions added.
Page 82: HDM(61) and RDM(60) added to section introduction.
Pages 95, 103, 104: IR bits corrected to SR bits.
Pages 95 to 103: Counter number specified for HDM(61) in programming.
Pages 103, 104: “High-speed” removed from description of RDM(60) and warning
added that RDM(60) is not a high-speed counter.
Page 105: Counter number specified for RDM(60) in programming.
Page 128: Maximum number of steps in one program specified as being 16.
Page 170: PROM Writer model number updated to C500-PRW06.
Address change.
Precautions section added in front of Section 1.
47, 49, 51, 54–56, 60, 88, 89, 91, 92, 93, 95, 98, 100, 110, 111, 121, 122, 161
Revision History
Revision code
Revised content
219