866 B&K Precision, 866 Datasheet - Page 85

• Manufacturer Part Number: 866
• Description: PROGRAMMER UNIV W/ USB INTERFACE
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 866

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: EPROM, EEPROM-Flash, Serial EPROM, Microcontroller & PLD
• Other names: 866BK; Q2005647

Manipulation with the programmed
device
Problems
interconnection, and their removing
printer port, substitute the programmer cable for the printer
cable. Connect the opposite cable end to the programmer.
Screw on both connectors to counter connectors. This is very
important mainly for the connector to programmer. Though
replacing the printer cable by the programmer cable is
uncomfortable, it is not recommended to operate the 848A
programmer through a mechanical printer switch. Use of an
electronic printer switch isn't possible.
Connect the mains connector of the power supply (or wall-plug
power supply self) to a mains plug, connect the connector to
the appropriate programmer's connector. Then, on the
programmer lights up LED POWER and the programmer 848A
is ready to run. Next switch on the PC and run the control
program.
Caution! If you don't want to switch off your PC when
connecting the 848A, proceed as follows:
• When connecting the programmer to the PC: FIRST insert
• When disconnecting the programmer from the PC: FIRST
If you have any problems with 848A
see section Common notes please.
After selection of desired device for your work, you can insert
into the open ZIF socket (the lever is up) and close socket (the
lever is down). The correct orientation of the programmed
device in ZIF socket is shown on the picture near ZIF socket
on the programmer's cover. The programmed device is
necessary to insert into the socket also to remove from the
socket when LED BUSY light off.
Warning: 848A programmer hasn’t protection devices, which
protect the content of programmed device against critical
situations, for example power failures and PC failure
(interrupted cable...). Moreover, a device is usually destroyed
in the programming mode due to forced interruption of the
control program run (Reset or switching the computer off) due
to removing the connecting cable, or unplugging the
the communications cable and THEN the power-supply
connector.
disconnect the power-supply connector and THEN the
communication cable.
related to
85
the
848A
PC interconnection,
PC