HS7046EPH60H Renesas Electronics America, HS7046EPH60H Datasheet - Page 228

• Manufacturer Part Number: HS7046EPH60H
• Description: DEV EMULATOR BASE SH7046
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: Microcontrollerr

Specifications of HS7046EPH60H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: SH7046
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.11
5.11.1
To operate the High-performance Embedded Workshop according to the description of section 4, Tutorial, the
following procedures must be added or modified.
Table 5.11 Notes on Operating the Tutorial Program
4.6 Executing the
Program
4.12.3 Executing the
[Step Over] Command
5.12
5.12.1
1. The emulator manages areas in the memory blocks shown in figures 5.1 and 5.2. Emulation memory and
2.
External Operating Frequency
50 MHz
40 MHz or lower
5.12.2
The memory map is divided into the 128-kbyte, 1-Mbyte, or 2-Mbyte blocks in each CS area. The accessing
attribute can be changed in a unit of each block. For the size of blocks used for each CS area, refer to figure 5.1
or 5.2.
This emulator incorporates the 4-Mbyte emulation memory, which can be divided into 128 kbytes (x 16) and 1
Mbyte (x 2).
The emulation memory can also be set in a unit of each block (figure 5.1 or 5.2), as well as in the accessing
attribute. Some 128-kbyte emulation memory is set for the 1-Mbyte or 2-Mbyte blocks. However, the remaining
area of the allocated block cannot be used. This also applies to a case when one 1-Mbyte emulation memory is
allocated to the 2-Mbyte blocks.
140
user memory cannot coexist in a single block.
When emulation memory is used in 50-MHz operation, one or more cycles are required as wait-state cycles
for access to those areas to which emulation memory is allocated. When emulation memory is used, refer to
the table below and set the number of wait cycles for the bus-state controller.
Memory Map
Tutorial Program
Notes on Operating the Tutorial Program
Emulation Memory
Controlling Memory Map
Reset the target MCU before executing the program. Refer to section 4.14,
Resetting the Target MCU for how to reset the target MCU.
In this product, after execution of [Step Out], execution stops at the statement where
the sort function is called. Before executing the [Step Over] command, execute the
[Step In] command once so that the execution stops at the statement where the
change function is called.
0
Number of Required Wait Cycles
One or more