HS7046EPH60H Renesas Electronics America, HS7046EPH60H Datasheet - Page 144

• Manufacturer Part Number: HS7046EPH60H
• Description: DEV EMULATOR BASE SH7046
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: Microcontrollerr

Specifications of HS7046EPH60H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: SH7046
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[Address]:
[Data]:
[Bus/Area]:
[Probe]:
[Interrupt]:
[Count]:
[Delay]:
Notes: 1. The settings to be made on pages [Address], [Data], [Bus/Area], [Probe], [Interrupt], and [Count] are
56
2.
3.
[Output Trigger]:
the same as those for on-emulator break conditions. For details on the on-emulator break conditions,
refer to section 3.7, Using the Event Points.
Set the range in the address range trace so that value of the end address will be larger than that of the
start address.
Two channels are used in the address range conditional trace. To perform the address range
conditional trace, select an odd-numbered channel (2n + 1) for the address range trace and an even-
numbered channel (2n) for the conditional trace, respectively, and then check [Combination with the
next channel].
[Start]:
[End]:
[f()…]:
Sets address conditions.
Sets data conditions.
Sets access type, bus status, and read/write cycle conditions.
Sets the levels (high or low) of the external probe signals (PRB1 to PRB4) as the condition.
Sets the levels (high or low) of the IRQ and NMI signals as the condition.
Sets a satisfaction count condition.
Sets the number of bus cycles delayed after the satisfaction of a trace condition. This function
allows you to check the trace information before/after any of the specified conditions are
satisfied. When [Don’t Care] has been selected, there is no delay.
Outputs a trigger after the satisfaction of a trace condition.
Set the start address.
Set the end address.
The address range of a function can be set by [Start] and [End].