DK-DEV-3CLS200N Altera, DK-DEV-3CLS200N Datasheet - Page 38

• Manufacturer Part Number: DK-DEV-3CLS200N
• Description: KIT DEV CYCLONE III LS EP3CLS200
• Manufacturer: Altera
• Series: Cyclone® IIIr
• Type: FPGAr

Specifications of DK-DEV-3CLS200N

• Contents: Board
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Cyclone
• Silicon Core Number: EP3C
• Silicon Family Name: Cyclone III LS
• Rohs Compliant: Yes
• For Use With/related Products: EP3CLS200
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2601

A–4
Restoring the Flash Device to the Factory Settings
Cyclone III LS FPGA Development Kit User Guide
f
11. Set the PGM/USER LOAD switch (SW2.6) to the off position and power cycle the
Programming the board is now complete.
For more information about the nios2-flash-programmer utility, refer to the
Flash Programmer User
This section describes how to restore the original factory contents to the flash memory
device on the development board. Make sure you have the Nios II EDS installed, and
perform the following instructions:
1. Set the board switches to the factory default settings described in
2. Launch the Quartus II Programmer to configure the FPGA with a .sof capable of
3. Click Add File and select <install
4. Turn on the Program/Configure option for the added file.
5. Click Start to download the selected configuration file to the FPGA. Configuration
6. On the Windows Start menu, click All Programs > Altera > Nios II EDS > Nios II
7. In the Nios II command shell, navigate to the <install
8. After all flash programming completes, cycle the POWER switch (SW1) off then
9. Using the Quartus II Programmer, click Add File and select <install
10. Turn on the Program/Configure option for the added file.
11. Click Start to download the selected configuration file to the FPGA. Configuration
board, or press the PGM_SELECT button (S9) until the PROGRAM LED1 LED
(D30) illuminates and then press the PGM CONFIG button (S8) to load and run the
user design. Refer to
LEDs.
Switch Settings” on page
flash programming. Refer to
Programmer” on page 6–16
dir>\kits\cycloneIIILS_3cls200_fpga\factory_recovery\c3ls200_fpga_bup.sof.
is complete when the progress bar reaches 100%. The CONF DONE LED (D14)
and the four user LEDs (D25-D28) illuminate indicating that the flash device is
ready for programming.
Command Shell.
dir>\kits\cycloneIIILS_3cls200_fpga\factory_recovery directory and type the
following command to run the restore script:
./restore.sh r
Restoring the flash memory might take several minutes. Follow any instructions
that appear in the Nios II command shell.
on.
dir>\kits\cycloneIIILS_3cls200_fpga\factory_recovery\c3ls200_fpga_bup.sof.
is complete when the progress bar reaches 100%. The CONF DONE LED (D14)
and the four user LEDs (D25-D28) illuminate indicating the flash memory device
is now restored with the factory contents.
Guide.
Table 6–1 on page 6–5
4–2.
for more information.
“Configuring the FPGA Using the Quartus II
Appendix A: Programming the Flash Memory Device
for information about the PROGRAM
Restoring the Flash Device to the Factory Settings
© October 2009 Altera Corporation
“Factory Default
Nios II