CYII5SC1300-EVAL Cypress Semiconductor Corp, CYII5SC1300-EVAL Datasheet - Page 21

• Manufacturer Part Number: CYII5SC1300-EVAL
• Description: BOARD EVAL IMG SENS IBIS5-B-1300
• Manufacturer: Cypress Semiconductor Corp

Specifications of CYII5SC1300-EVAL

• Sensor Type: CMOS Imaging, Color (RGB)
• Sensing Range: 1.3 Megapixel
• Interface: Parallel/Serial
• Sensitivity: 106 fps
• Voltage - Supply: 3 V ~ 4.5 V
• Embedded: No
• Utilized Ic / Part: IBIS5-B-1300
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

Document #: 38-05710 Rev. *A
Windowing in Y-direction
A new Y-pointer can be loaded into the Y-shift-register, by
reapplying the Y_START pulse after loading a new Y-pointer
value into the YL_REG and YR_REG registers.
Every time a Y_START pulse appears, a frame calibration of
the output amplifier is performed.
Initialization (start-up behavior)
To avoid any high current consumption at start-up, it is recom-
mended to apply the SYS_CLOCK signal as soon as possible
after or even before power-on of the image sensor.
Figure 27. Windowing in the Y-direction
After power-on of the image sensor, it is recommended to
apply SYS_RESET for a minimum of 5 SYS_CLOCK periods
to ensure a proper reset of the on-chip sequencer and timing
circuitry. All internal registers will be set to ‘0’ after
SYS_RESET is applied.
Since all the IBIS5-B-1300 control signals are active high, it is
also recommended to apply a low level (before SYS_RESET
occurs) to these pins at start up to avoid latch up.
CYII5FM1300AB
IBIS5-B-1300
Page 21 of 42
[+] Feedback