STEVAL-IFS006V1 STMicroelectronics, STEVAL-IFS006V1 Datasheet - Page 93

• Manufacturer Part Number: STEVAL-IFS006V1
• Description: BOARD EVAL 8BIT MICRO + TDE1708
• Manufacturer: STMicroelectronics

Specifications of STEVAL-IFS006V1

• Design Resources: STEVAL-IFS006V1 Bill of Material
• Sensor Type: Proximity
• Interface: I²C
• Voltage - Supply: 6 V ~ 48 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FLITEUS5, TDE1708
• Processor To Be Evaluated: ST7LITEUS5
• Data Bus Width: 8 bit
• Operating Supply Voltage: 6 V to 48 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: TDE1708DFT
• Kit Application Type: Sensing - Touch / Proximity
• Application Sub Type: Proximity Switch
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-6403; STEVAL-IFS006V1

ST7LITEUS2, ST7LITEUS5
12.1.5
12.2
Pin input voltage
The input voltage measurement on a pin of the device is described in
Figure 38. Pin input voltage
Absolute maximum ratings
Stresses above those listed as “absolute maximum ratings” may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
1. Directly connecting the I/O pins to V
change of the I/O configuration occurs (for example, due to a corrupted program counter).
To guarantee safe operation, this connection has to be done through a pull-up or pull-down
resistor (typical: 10 kΩ for I/Os). Unused I/O pins must be tied in the same way to V
V
Table 43.
1. I
SS
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
INJ(PIN)
according to their reset configuration.
V
V
V
Symbol
ESD(HBM)
DD
ESD(MM)
V
- V
IN
must never be exceeded. This is implicitly insured if V
SS
Voltage characteristics
Supply voltage
Input voltage on any pin
Electrostatic discharge voltage (Human Body
Model)
Electrostatic discharge voltage (Machine
Model)
IN
>V
DD
while a negative injection is induced by V
Ratings
V
DD
IN
(1)
or V
SS
could damage the device if an unexpected
ST7 PIN
IN
maximum is respected. If V
IN
V
INJ(PIN)
<V
Maximum value
SS
Electrical characteristics
SS
-0.3 to V
.
see
see
value. A positive
Figure
7.0
Section 12.7.2
Section 12.7.2
DD
IN
38.
+0.3
maximum
DD
Unit
93/136
V
or