SCD1284 INTEL [Intel Corporation], SCD1284 Datasheet - Page 86

• Manufacturer Part Number: SCD1284
• Description: IEEE 1284-Compatible Parallel Interface Controller with Two High-Speed Asynchronous Serial Ports
• Manufacturer: INTEL [Intel Corporation]

CD1284 — IEEE 1284-Compatible Parallel Interface Controller
5.17
5.17.1
5.17.2
5.17.3
86
Figure 14. External Buffer Control
TO CD1284
PDBEN
EBDIR
Hardware Configurations
The simplicity of the CPU interface to the CD1284 allows the device to be designed into systems
that employ popular microprocessors such as the Intel 80x86 family (8086, 80286, 80386, and so
on), the Motorola family (68000, 68010, 68020, and so on), the National Semiconductor 32x32
family (32CG16, 32332, 32532, 32GX32, and so on), and the AMD 29000.
Interfacing to an Intel Microprocessor-Based System
With very little extra logic, the CD1284 can interface to any system based on a processor in the
Intel 80x86 family.
based system. To provide the proper strobes and controls, the IOR* and IOW* control strobes
synthesize the DS* and R/W* signals. DTACK* is used as an input to wait-state-generation logic
that holds the processor (if necessary) until the CD1284 has completed the I/O request.
Interfacing to a Motorola Microprocessor-Based System
Interfacing to a 68000 family device is relatively simple. Bus timing and the interface signal
definitions closely match those of the 68000 microprocessor, which allows a direct connection in
most cases. With later versions (68020, 68030), some additional logic is required to generate the
DSACK0* and DSACK1* functions that replace the DTACK* on earlier devices. The example in
Figure 16 on page 88
Interfacing to a National Semiconductor
Microprocessor-Based System
The connections between the CD1284 and an NS32000 (32GX320, 32CG16, and so on) embedded
controller are also relatively simple. As with the Intel devices, cycles are controlled by the DS*,
CS*, and R/W* signals synthesized from the available I/O-control signals. I/O-cycle extensions
(wait states) are generated by logic connected to the DTACK* signal. All necessary controls are
available to prevent multiple read/write cycles in the CD1284 FIFOs when using memory-mapped
I/O.
Figure 15
shows a generalized interface to a 68020 device.
shows a generalized view of an I/O-mapped interface with an 80286-
B
G
DIR
Impedance matching and protection circuitry
(see
Figure
A
13) as required for the 74AS245.
TO CABLE
Datasheet