ZL30402/QCC ZARLINK [Zarlink Semiconductor Inc], ZL30402/QCC Datasheet - Page 7

• Manufacturer Part Number: ZL30402/QCC
• Description: SONET/SDH Network Element PLL
• Manufacturer: ZARLINK [Zarlink Semiconductor Inc]

Pin Description (continued)
66-69
Pin #
53
54
55
56
57
58
59
60
61
62
63
64
65
70
71
72
73
HOLDOVER
C34/C44
D0 - D3
RESET
Name
LOCK
GND
VDD
VDD
HW
NC
NC
DS
OE
CS
IC
IC
IC
IC
Clock 34.368 MHz / clock 44.736 MHz (CMOS Output). This clock is
programmable to be either 34.368 MHz (for E3 applications) or 44.736 MHz
(for DS3 applications) when E3DS3/OC3 is high, or to be either 8.592MHz or
11.184 MHz when E3DS3/OC3 is low. See description of E3DS3/OC3 and
E3/DS3 inputs for details. In Software Control the functionality of this output is
controlled by Control Register 2 (Table 7 "Control Register 2 (R/W)").
Positive Power Supply.
Holdover Indicator (CMOS output). Logic high at this output indicates that the
device is in Holdover mode.
No internal bonding Connection. Leave unconnected.
Lock Indicator (CMOS output). Logic high at this output indicates that
ZL30402 is locked to the input reference.
No internal bonding Connection. Leave unconnected.
Data Strobe (5 V tolerant input). This input is the active low data strobe of the
processor interface.
Internal Connection. Connect to ground.
Internal Connection. Leave unconnected.
Output Enable (Input). Logic high on this input enables C19, F16, C16, C8,
C6, C4, C2, C1.5, F8 and F0 signals. Pulling this input low will force the output
clocks pins into a high impedance state.
Chip Select (5 V tolerant input). This active low input enables the
microprocessor interface. When CS is set to high, the microprocessor interface
is idle and all Data Bus I/O pins will be in a high impedance state.
RESET (5 V tolerant input). This active low input forces the ZL30402 into a
RESET state. The RESET pin must be held low for a minimum of 1µs to reset
the device properly. The ZL30402 must be reset after power-up.
Hardware/Software Control (Input). If this pin it tied low, the ZL30402 is
controlled via the microport. If it is tied high, the ZL30402 is controlled via the
control pins MS1, MS2, FCS, RefSel, RefAlign, E3/DS3 and E3DS3/OC3.
Data 0 to Data 3 (5 V tolerant three-state I/O). These signals combined with
D4 - D7 form the bi-directional data bus of the microprocessor interface (D0 is
the least significant bit).
Ground.
Internal Connection (Input). Connect this pin to ground.
Internal Connection (Input). Connect this pin to ground.
Positive Power Supply.
Zarlink Semiconductor Inc.
ZL30402
7
Description
Data Sheet