SB82371 Intel Corporation, SB82371 Datasheet - Page 34

• Manufacturer Part Number: SB82371
• Description: 82371FB (PIIX) AND 82371SB (PIIX3) PCI ISA IDE XCELERATOR
• Manufacturer: Intel Corporation

82371FB (PIIX) AND 82371SB (PIIX3)
increase the delay in increments of SYSCLKs. No additional delay is inserted for back-to-back I/O "sub
cycles" generated as a result of byte assembly or disassembly. This register defaults to 8 and 16-bit recovery
enabled with one SYSCLK clock added to the standard I/O recovery.
2.2.9.
Address Offset:
Default Value:
Attribute:
This register enables/disables accesses to the RTC, keyboard controller, IOAPIC (PIIX3 only), and BIOS.
Disabling any of these bits prevents the chip select and X-Bus output enable control signal (XOE#) for that
device from being generated. This register also provides coprocessor error and mouse functions.
34
7
6
5:3
2
1:0
Bit
XBCS—X-BUS CHIP SELECT REGISTER (Function 0)
DMA Reserved Page Register Aliasing Control (DMAAC). When DMAAC=0, the PIIX/PIIX3
aliases I/O accesses in the 90–9Fh range to the 80–8Fh range. In this case, the PIIX/PIIX3
only forwards write accesses to these locations to the ISA Bus.
PIIX: When DMAAC=1, the PIIX disables aliasing for the following registers; 80h, 84 86h, 88h,
and 8C 8Eh. When disabled, the PIIX forwards read and write accesses to these registers to
the ISA.
PIIX3: When DMAAC=1, the PIIX3 disables aliasing for the entire 90–9Fh range (they are
considered ISA bus register locations). When disabled, the PIIX3 forwards read ands write
accesses to these registers to ISA.
Note, that port 92h is always a distinct ISA register in the 90–9Fh range and is always
forwarded to the ISA Bus. When DMAAC=1, ISA master accesses to the 90–9Fh range are
ignored by the PIIX. Also, when DMAAC=1, the PIIX/PIIX3 does not re-load the power
management fast-off-timer with its original value for accesses to the 90–9Fh address range.
8-Bit I/O Recovery Enable. 1=Enable the recovery time programmed in bits [5:3]. 0=Disable
recovery times in bits [5:3] and the recovery timing of 3.5 SYSCLKs is inserted.
8-Bit I/O Recovery times. When bit 6=1, this 3-bit field defines the recovery time for 8-bit I/O.
Bit[5:3]
001
010
011
100
16-Bit I/O Recovery Enable. 1=Enable, the recovery times programmed in bits [1:0].
0=Disable, programmable recovery times in bits [1:0] and the recovery timing of 3.5 SYSCLKs
is inserted.
16-Bit I/O Recovery Times. When bit 2=1, this 2-bit defines the recovery time for 16-bit I/O.
Bit[1:0]
01
10
11
00
4Eh (PIIX)
4E 4Fh (PIIX3)
03h
Read/Write
SYSCLK
1
2
3
4
SYSCLK
1
2
3
4
Bit[5:3]
101
110
111
000
Description
SYSCLK
5
6
7
8