A25L05P AMICC [AMIC Technology], A25L05P Datasheet - Page 23

• Manufacturer Part Number: A25L05P
• Description: 2Mbit / 1Mbit / 512Kbit, Low Voltage, Serial Flash Memory With 85MHz SPI Bus Interface
• Manufacturer: AMICC [AMIC Technology]

Bulk Erase (BE)
The Bulk Erase (BE) instruction sets all bits to 1 (FFh). Before
it can be accepted, a Write Enable (WREN) instruction must
previously have been executed. After the Write Enable
(WREN) instruction has been decoded, the device sets the
Write Enable Latch (WEL).
The Bulk Erase (BE) instruction is entered by driving Chip
Select (
Data Input (DIO). Chip Select (
entire duration of the sequence.
The instruction sequence is shown in Figure 14. Chip Select
(
code has been latched in, otherwise the Bulk Erase instruction
Figure 14. Bulk Erase (BE) Instruction Sequence
(August, 2007, Version 1.0)
S
) must be driven High after the eighth bit of the instruction
S
) Low, followed by the instruction code on Serial
DIO
S
Note: Address bits A23 to A18 are Don’t Care, for A25L20P.
C
S
) must be driven Low for the
Address bits A23 to A17 are Don’t Care, for A25L10P.
Address bits A23 to A16 are Don’t Care, for A25L05P
0
1 2 3
22
Instruction
is not executed. As soon as Chip Select (
the self-timed Bulk Erase cycle (whose duration is t
initiated. While the Bulk Erase cycle is in progress, the Status
Register may be read to check the value of the Write In
Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during
the self-timed Bulk Erase cycle, and is 0 when it is completed.
At some unspecified time before the cycle is completed, the
Write Enable Latch (WEL) bit is reset.
The Bulk Erase (BE) instruction is executed only if all Block
Protect (BP1, BP0) bits are 0. The Bulk Erase (BE) instruction
is ignored if one, or more, sectors are protected.
A25L20P/A25L10P/A25L05P Series
4 5 6 7
AMIC Technology Corp.
S
) is driven High,
BE
) is