ia186es Innovasic Semiconductor Inc., ia186es Datasheet - Page 93

no-image

ia186es

Manufacturer Part Number
ia186es
Description
8-bit/16-bit Microcontrollers
Manufacturer
Innovasic Semiconductor Inc.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ia186es-PQF100I-R-03
Manufacturer:
INNOVASIC
Quantity:
1 704
Part Number:
ia186es-PQF100I-R-03
Manufacturer:
Innovasic Semiconductor
Quantity:
10 000
Company:
Part Number:
ia186es-PQF100I-R-03
Quantity:
11
Part Number:
ia186es-PTQ100I-R-03
Manufacturer:
TOSHIBA
Quantity:
53
Part Number:
ia186es-PTQ100I-R-03
Manufacturer:
Innovasic Semiconductor
Quantity:
10 000
Part Number:
ia186esPQF100IR03
Manufacturer:
ADI/亚德诺
Quantity:
20 000
IA186ES/IA188ES
8-Bit/16-Bit Microcontrollers
5.1.32 T2COMPA (062h), T1COMPB (05ch), T1COMPA (05ah), T0COMPB (054h), and
Timer Maxcount COMpare Registers. These registers contain the maximum count value that is
compared to the respective count register. Timer0 and Timer1 have two of these compare
registers each.
If Timer0 and/or Timer1 is/are configured to count and compare firstly to register A and then
register B, the TMROUT0 or TMROUT1 signals may be used to generate various duty-cycle
wave forms.
Timer2 has only one compare register, T2COMPA.
If one of these timer maxcount compare registers is set to 0000h, the respective timer will count
from 0000h to FFFFh before generating an interrupt request. For example, a timer configured in
this manner with a 40-MHz clock will interrupt every 6.5536 µS.
The value of these registers is 0000h at reset (see Table 53).
Table 53. Timer Maxcount Compare Registers
5.1.33 T2CNT (060h), T1CNT (058h), and T0CNT (050h)
Timer CouNT Registers. These registers are incremented by one every four internal clock cycles
if the relevant timer is enabled.
The Increment of Timer0 and Timer1 may also be controlled by external signals tmrin0 and
tmrin1 respectively, or prescaled by Timer2.
15
14
Bit [5]—MC Maximum Count → When the timer reaches its maximum count, this bit is
set to 1 regardless of the interrupt enable bit. This bit may be used by software polling to
monitor timer status rather than through interrupts if desired.
Bits [4–1]—Reserved. Set to 0.
Bit [0]—CONT Continuous Mode Bit → The timer will run continuously when this bit is
set to 1. The timer will stop after each count run and EN will be cleared if this bit is set
to 0.
Bits [15–0]—TC [15–0] Timer Compare Value → The timer will count to the value in the
respective register before resetting the count value to 0.
T0COMPA (052h)
13
12
11
®
10
TC15–TC0
9
8
7
UNCONTROLLED WHEN PRINTED OR COPIED
6
5
Page 93 of 154
IA211050902-15
4
3
2
1
0
December 24, 2008
http://www.Innovasic.com
Customer Support:
Data Sheet
1-888-824-4184

Related parts for ia186es