com20020-5 Standard Microsystems Corp., com20020-5 Datasheet - Page 40

• Manufacturer Part Number: com20020-5
• Description: Com20020-5 Ulanc Universal Local Area Network Controller With 2k X 8 On-board Ram
• Manufacturer: Standard Microsystems Corp.

of 128 or 4.
number of times the EXCNAK bit goes high, and
once the final count is reached, the "Disable
Transmitter" command may be issued.
The New Next ID bit permits the software to
detect the withdrawal or addition of nodes to the
network.
The Tentative ID bit allows the user to build a
network map of those nodes existing on the
network.
minimizes the need for human intervention.
When a value placed in the Tentative ID
Register matches the Node ID of another node
on the network, the TENTID bit is set, telling the
software that this NODE ID already exists on the
network. The software should periodically place
values in the Tentative ID Register and monitor
the New Next ID bit to maintain an updated
network map.
This feature is useful because it
47pF
The software may count the
40 MHz
Third Overtone such
EC400-40.0000
FIGURE 9 – OSCILLATOR CIRCUIT
as Ecliptek
47pF
40
1k
OSCILLATOR
The COM20020-5 contains circuitry which, in
conjunction with an external parallel resonant
crystal or TTL clock, forms an oscillator.
If an external crystal is used, two capacitors and
one resistor are needed (one from each leg of
the crystal to ground).
required, and the crystal must have an accuracy
of 0.020% or better.
The XTAL2 side of the crystal may be loaded
with a single 74HC-type buffer in order to
generate a clock for other devices.
The user may attach an external TTL clock,
rather than a crystal, to the XTAL1 signal. In
this case, a 390
XTAL1,
unconnected.
XTAL1
XTAL2
COM20020-5
while
pull-up resistor is required on
XTAL2
A 1K
should
resistor is
be
left