cs4237b Cirrus Logic, Inc., cs4237b Datasheet - Page 80

• Manufacturer Part Number: cs4237b
• Description: Crystalclear Advanced Audio System With 3d Sound
• Manufacturer: Cirrus Logic, Inc.

CONVERTER CALIBRATION (CAL1,0 = 01)
This calibration mode calibrates the ADCs and
the DACs, but does not calibrate any of the ana-
log mixing channels. This is the second longest
calibration mode, taking 321 sample periods at
44.1 kHz. Because the analog mixer is not cali-
brated in this mode, any signals fed through the
mixer will be unaffected. The calibration se-
quence is as follows:
DAC CALIBRATION (CAL1,0 = 10)
This calibration mode only clears the DACs
(playback) interpolation filters leaving the ADC
unaffected. This is the second fastest calibration
mode (no cal. is the fastest) taking 120 sample
periods at 44.1 kHz to complete. The calibration
sequence is as follows:
FULL CALIBRATION (CAL1, 0 = 11)
This calibration mode calibrates all offsets,
ADCs, DACs, and analog mixers. Full calibra-
tion will automatically be initiated on power up
or anytime the WSS Codec exits from a full
power down state. This is the longest calibration
mode and takes 450 sample periods at 44.1 kHz
to complete. The calibration sequence is as fol-
lows:
80
The DACs are muted
The ADCs are calibrated
The DACs are calibrated
The DACs are unmuted
The DACs are muted
The DAC filters are cleared
The DACs are unmuted
All outputs are muted (DACs and mixer)
The mixer is calibrated
The ADCs are calibrated
The DACs are calibrated
All outputs are unmuted
Changing Sampling Rate
The internal states of the WSS Codec are syn-
chronized by the selected sampling frequency.
The sample frequency can be set in one of three
fashions. The standard WSS Codec method uses
the Fs & Playback Data Format register (I8) to
set the sample frequency. The changing of either
the clock source or the clock frequency divide
requires a special sequence for proper WSS
Codec operation:
1) Place the WSS Codec in Mode Change En-
2) During a single write cycle, change the Clock
3) The WSS Codec resynchronizes its internal
4) The host now polls the WSS Codec’s Index
5) Once the WSS Codec is no longer responding
A second method of changing the sample fre-
quency is to disable the sample frequency bits in
I8 (lower four bits) by setting SRE in I22. When
this bit is set, OSM1 and OSM0 in I10, along
able using the MCE bit of the Index Address
register (R0).
Frequency Divide Select (CFS) and/or
Clock 2 Base Select (C2SL) bits of the Fs &
Playback Data Format register (I8) to the de-
sired value. (The data format may also be
changed.)
states to the new frequency. During this time
the WSS Codec will be unable to respond.
Writes to the WSS Codec will not be recog-
nized and reads will always return the value
80 hex.
Address register (R0) until the value 80 hex
is no longer returned. On slow processor sys-
tems, 80h may occur to fast; therefore, it
may never be seen by software.
to reads with a value of 80 hex, normal op-
eration can resume and the WSS Codec can
be removed from MCE.
CS4237B
DS213PP4