ds3102 Maxim Integrated Products, Inc., ds3102 Datasheet - Page 126

• Manufacturer Part Number: ds3102
• Description: Stratum 3 Timing Card Ic With Synchronous Ethernet Support
• Manufacturer: Maxim Integrated Products, Inc.

9.3
The instruction register contains a shift register as well as a latched parallel output and is 3 bits in length. When the
TAP controller enters the Shift-IR state, the instruction shift register is connected between JTDI and JTDO. While in
the Shift-IR state, a rising edge on JTCLK with JTMS low shifts data one stage toward the serial output at JTDO. A
rising edge on JTCLK in the Exit1-IR state or the Exit2-IR state with JTMS high moves the controller to the Update-
IR state. The falling edge of that same JTCLK latches the data in the instruction shift register to the instruction
parallel output.
codes.
Table 9-1. JTAG Instruction Codes
SAMPLE/PRELOAD. SAMPLE/RELOAD is a mandatory instruction for the IEEE 1149.1 specification. This
instruction supports two functions. First, the digital I/Os of the device can be sampled at the boundary scan
register, using the Capture-DR state, without interfering with the device’s normal operation. Second, data can be
shifted into the boundary scan register through JTDI using the Shift-DR state.
EXTEST. EXTEST allows testing of the interconnections to the device. When the EXTEST instruction is latched in
the instruction register, the following actions occur: (1) Once the EXTEST instruction is enabled through the
Update-IR state, the parallel outputs of the digital output pins are driven. (2) The boundary scan register is
connected between JTDI and JTDO. (3) The Capture-DR state samples all digital inputs into the boundary scan
register.
BYPASS. When the BYPASS instruction is latched into the parallel instruction register, JTDI is connected to JTDO
through the 1-bit bypass register. This allows data to pass from JTDI to JTDO without affecting the device’s normal
operation.
IDCODE. When the IDCODE instruction is latched into the parallel instruction register, the device identification
register is selected. The device ID code is loaded into the device identification register on the rising edge of JTCLK,
following entry into the Capture-DR state. Shift-DR can be used to shift the ID code out serially through JTDO.
During Test-Logic-Reset, the ID code is forced into the instruction register’s parallel output.
HIGHZ. All digital outputs are placed into a high-impedance state. The bypass register is connected between JTDI
and JTDO.
CLAMP. All digital output pins output data from the boundary scan parallel output while connecting the bypass
register between JTDI and JTDO. The outputs do not change during the CLAMP instruction.
Rev: 012108
____________________________________________________________________________________________ DS3102
SAMPLE/PRELOAD
INSTRUCTIONS
JTAG Instruction Register and Instructions
BYPASS
EXTEST
IDCODE
CLAMP
HIGHZ
Table 9-1
shows the instructions supported by the DS3102 and their respective operational binary
SELECTED REGISTER
Device Identification
Boundary Scan
Boundary Scan
Bypass
Bypass
Bypass
INSTRUCTION CODES
010
111
000
011
100
001
126 of 141