LM3S300 Luminary Micro, Inc, LM3S300 Datasheet - Page 49

• Manufacturer Part Number: LM3S300
• Description: Lm3s300 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

6
6.1
6.1.1
6.1.2
6.1.2.1
6.1.2.2
June 04, 2008
System Control
System control determines the overall operation of the device. It provides information about the
device, controls the clocking to the core and individual peripherals, and handles reset detection and
reporting.
Functional Description
The System Control module provides the following capabilities:
■
■
■
Device Identification
Seven read-only registers provide software with information on the microcontroller, such as version,
part number, SRAM size, flash size, and other features. See the DID0, DID1, and DC0-DC4 registers.
Reset Control
This section discusses aspects of hardware functions during reset as well as system software
requirements following the reset sequence.
Reset Sources
The controller has six sources of reset:
1.
2.
3.
4.
5.
6.
After a reset, the Reset Cause (RESC) register is set with the reset cause. The bits in this register
are sticky and maintain their state across multiple reset sequences,except when an external reset
is the cause, and then all the other bits in the RESC register are cleared.
Note:
RST Pin Assertion
The external reset pin (RST) resets the controller. This resets the core and all the peripherals except
the JTAG TAP controller (see “JTAG Interface” on page 39). The external reset sequence is as
follows:
Device identification, see “Device Identification” on page 49
Local control, such as reset (see “Reset Control” on page 49), power (see “Power
Control” on page 52) and clock control (see “Clock Control” on page 52)
System control (Run, Sleep, and Deep-Sleep modes), see “System Control” on page 55
External reset input pin (RST) assertion, see “RST Pin Assertion” on page 49.
Power-on reset (POR), see “Power-On Reset (POR)” on page 50.
Internal brown-out (BOR) detector, see “Brown-Out Reset (BOR)” on page 50.
Software-initiated reset (with the software reset registers), see “Software Reset” on page 51.
A watchdog timer reset condition violation, see “Watchdog Timer Reset” on page 52.
Internal low drop-out (LDO) regulator output
The main oscillator is used for external resets and power-on resets; the internal oscillator
is used during the internal process by internal reset and clock verification circuitry.
Preliminary
LM3S300 Microcontroller
49