ST92185B STMicroelectronics, ST92185B Datasheet - Page 76

• Manufacturer Part Number: ST92185B
• Description: 16k/24k/32k Rom Hcmos Mcu With On-screen-display
• Manufacturer: STMicroelectronics

ST92185B - TIMER/WATCHDOG (WDT)
TIMER/WATCHDOG (Cont’d)
7.1.3.3 Preventing Watchdog System Reset
In order to prevent a system reset, the sequence
AAh, 55h must be written to WDTLR (Watchdog
Timer Low Register). Once 55h has been written,
the Timer reloads the constant and counting re-
starts from the preset value.
To reload the counter, the two writing operations
must be performed sequentially without inserting
other instructions that modify the value of the
WDTLR register between the writing operations.
The maximum allowed time between two reloads
of the counter depends on the Watchdog timeout
period.
Figure 45. Watchdog Timer Mode
76/178
COUNT
VALUE
WRITE WDTRH,WDTRL
COUNT RELOAD
PRODUCE
WRITE AAh,55h
INTO WDTRL
WD EN=0
G
TIMER START COUNTING
7.1.3.4 Non-Stop Operation
In Watchdog Mode, a Halt instruction is regarded
as illegal. Execution of the Halt instruction stops
further execution by the CPU and interrupt ac-
knowledgment, but does not stop INTCLK, CPU-
CLK or the Watchdog Timer, which will cause a
System Reset when the End of Count condition is
reached. Furthermore, ST_SP, S_C and the Input
Mode selection bits are ignored. Hence, regard-
less of their status, the counter always runs in
Continuous Mode, driven by the internal clock.
The Output mode should not be enabled, since in
this context it is meaningless.
(E.G. INFINITE LOOP)
OR PERIPHERAL FAIL
SOFTWARE FAIL
VA00220
RESET