TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 251

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

<IGTRGSEL>=1
(start by rising edge)
MT0IN
(Signal after noise
eliminated)
MTOUT00/10
(Example)
10.6.14.2
counting. The operation is the same as that in command start and capture mode if there is no
trigger input on the MT0IN pin. If an edge specified with the start edge selection field (MT0IGICR
<IGTRGSEL>) appears on the MT0IN pin, however, the timer starts counting. The counter is
cleared and stopped while the MT0IN pin is driven to the specified clear/stop level. If the MT0IN pin
is at the clear/stop level when a count start command is issued (1 is written to MT0RUN <MTRUN>),
counting does not start (INTMTTB00 does not occur) until a trigger start edge appears, causing
INTMTTB01 to occur (A trigger input takes precedence over a command start).
mode”.
Writing a 1 to MT0RUN<MTRUN> causes the current count to be cleared and the counter to start
Note: For more information on the acceptance of a trigger, see “Trigger start/stop acceptance
Command start and Trigger start mode
Figure 10-11 Operation in Command start and Trigger start mode
No trigger, same as
trigger capture mode.
Period (MT0IGRG4)
Count
by command
TMPM380/M382 - 51 / 87 -
start
Count clear
re-start
Count
falling edge
Count stopped
stop
Count
clear
by
Count
rising edge
Count clear
re-start
start
TMPM380/M382
by