ST10R272L STMicroelectronics, ST10R272L Datasheet - Page 40

• Manufacturer Part Number: ST10R272L
• Description: 16-BIT Romless MCU WITH MAC UNIT
• Manufacturer: STMicroelectronics

Specifications of ST10R272L

• Cpu Frequency: 0 to 50 MHz
• Power: 3.3 Volt +/-0.3V

ST10R272L - ELECTRICAL CHARACTERISTICS
16
16.1 Absolute Maximum Ratings
•
•
•
•
•
•
•
•
•
Note
The parameters listed in this section represent both the ST10R272L controller characteristics
and the system requirements. To aid parameters interpretation in design evaluation, the a
symbol column is marked:
40/77
1
CC for Controller Characteristics: The ST10R272L logic provides signals with the
SR for System Requirement:
Ambient temperature under bias ( T
Storage temperature ( T
Voltage on V
Voltage on any pin with respect to ground ( V
Voltage on any 5V tolerant pin with respect to ground ( V
Voltage on any 5V fail-safe pin with respect to ground ( V
Input current on any pin during overload condition: .................................. –10 to +10 mA
Absolute sum of all input currents during overload condition: .............................|100 mA|
Power dissipation:.....................................................................................................1.0 W
ELECTRICAL CHARACTERISTICS
Stresses above those listed under “Absolute Maximum Ratings” may cause
permanent damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in the
operational sections of this specification is not guaranteed. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability. During
overload conditions (V
(V
SS
) must not exceed the values defined by the Absolute Maximum Ratings.
DD
pins with respect to ground ( V
ST
):....................................................................... – 65 to +150 °C
IN
>V
respective timing characteristics.
The external system must provide signals with the
respective timing characteristics to the ST10R272L.
DD
A
or V
): ......................................................... -40 to +85 °C
IN
<V
SS
SS
SS
) the voltage on pins with respect to ground
): ................................ –0.5 to V
):..................................... – 0.5 to +4.0 V
SS
SS
): .......................–0.5 to 5 .5 V
): .......................–0.5 to 5 .5 V
DD
+0.5 V