LPC2212_2214 NXP Semiconductors, LPC2212_2214 Datasheet - Page 2

• Manufacturer Part Number: LPC2212_2214
• Description: The LPC2212/2214 are based on a 16/32-bit ARM7TDMI-S CPU with real-time emulationand embedded trace support, together with 128/256 kB of embedded high-speed flashmemory
• Manufacturer: NXP Semiconductors

NXP Semiconductors
3. Ordering information
LPC2212_2214
Product data sheet















Table 1.
Type number
LPC2212FBD144/01
LPC2214FBD144/01
16 kB on-chip static RAM and 128/256 kB on-chip flash program memory. 128-bit wide
interface/accelerator enables high speed 60 MHz operation.
In-System Programming (ISP) and In-Application Programming (IAP) via on-chip
bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or
full chip erase takes 400 ms.
EmbeddedICE-RT and Embedded Trace interfaces offer real-time debugging with the
on-chip RealMonitor software as well as high speed real-time tracing of instruction
execution.
Eight-channel 10-bit ADC with conversion time as low as 2.44 s.
Two 32-bit timers (with four capture and four compare channels), PWM unit (six
outputs), Real-Time Clock and Watchdog.
Multiple serial interfaces including two UARTs (16C550), Fast I
two SPIs.
Vectored Interrupt Controller with configurable priorities and vector addresses.
Configurable external memory interface with up to four banks, each up to 16 MB and
8/16/32-bit data width.
Up to 112 general purpose I/O pins (5 V tolerant). Up to nine edge or level sensitive
external interrupt pins available.
60 MHz maximum CPU clock available from programmable on-chip Phase-Locked
Loop with settling time of 100 s.
On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.
Two low power modes, Idle and Power-down.
Processor wake-up from Power-down mode via external interrupt.
Individual enable/disable of peripheral functions for power optimization.
Dual power supply:


CPU operating voltage range of 1.65 V to 1.95 V (1.8 V  0.15 V).
I/O power supply range of 3.0 V to 3.6 V (3.3 V  10 %) with 5 V tolerant I/O pads.
Ordering information
All information provided in this document is subject to legal disclaimers.
Package
Name
LQFP144
LQFP144
Rev. 5 — 14 June 2011
Description
plastic low profile quad flat package; 144 leads;
body 20  20  1.4 mm
plastic low profile quad flat package; 144 leads;
body 20  20  1.4 mm
Single-chip 16/32-bit ARM microcontrollers
LPC2212/2214
2
C-bus (400 kbit/s) and
© NXP B.V. 2011. All rights reserved.
Version
SOT486-1
SOT486-1
2 of 47