SAM9261 Atmel Corporation, SAM9261 Datasheet - Page 126

• Manufacturer Part Number: SAM9261
• Manufacturer: Atmel Corporation

Specifications of SAM9261

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 160
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

ARM9E-S Coprocessor Interface
6.4
6-10
MCRR/MRRC
ARM processor pipeline
WDATA[31:0]
RDATA[31:0]
INSTR[31:0]
CHSD[1:0]
CHSE[1:0]
InMREQ
MCRR
Figure 6-4.
First InMREQ is driven LOW to denote that the instruction on INSTR[31:0] is
entering the Decode stage of the pipeline. This causes the coprocessor to decode the
new instruction and drive CHSD[1:0] as required.
In the next cycle InMREQ is driven LOW to denote that the instruction has now been
issued to the Execute stage. If the condition codes pass, and the instruction is to be
executed, the PASS signal is driven HIGH and the CHSD[1:0] handshake bus is
examined by the core (it is ignored in all other cases).
For any successive Execute cycles the CHSE[1:0] handshake bus is examined. When
the LAST condition is observed, the instruction proceeds to its final Execute cycle. In
the case of an
(MCRR)
(MRRC)
PASS
CLK
and
Copyright © 2000 ARM Limited. All rights reserved.
MRRC
MCRR
MCRR/MRRC
cycles look very similar to
, the WDATA[31:0] bus is driven with the first register data during
Decode
Figure 6-4 ARM9E-S MCRR or MRRC transfer timing
GO
Execute
(GO)
STC
LAST
or
Data1 (Rd)
Execute
(LAST)
LDC
. An example is shown in
Data1
Ignored
Data2 (Rn)
Memory
(LAST)
Data2
ARM DDI 0165B
(LAST)
Write