SAM3N4A Atmel Corporation, SAM3N4A Datasheet - Page 32

• Manufacturer Part Number: SAM3N4A
• Manufacturer: Atmel Corporation

Specifications of SAM3N4A

• Flash (kbytes): 256 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 48 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 79
• Ext Interrupts: 79
• Quadrature Decoder Channels: 2
• Usb Speed: No
• Usb Interface: No
• Spi: 2
• Twi (i2c): 2
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 24
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

8.1
8.2
8.2.1
8.2.2
8.2.3
32
System Controller and Peripheral Mapping
Power-on-Reset, Brownout and Supply Monitor
SAM3N
Power-on-Reset
Brownout Detector on VDDCORE
Supply Monitor on VDDIO
Please refer to
All the peripherals are in the bit band region and are mapped in the bit band alias region.
The SAM3N embeds three features to monitor, warn and/or reset the chip:
The Power-on-Reset monitors VDDIO. It is always activated and monitors voltage at start up but
also during power down. If VDDIO goes below the threshold voltage, the entire chip is reset. For
more information, refer to the “Electrical Characteristics” section of the datasheet.
The Brownout Detector monitors VDDCORE. It is active by default. It can be deactivated by soft-
ware through the Supply Controller (SUPC_MR). It is especially recommended to disable it
during low-power modes such as wait or sleep modes.
If VDDCORE goes below the threshold voltage, the reset of the core is asserted. For more infor-
mation, refer to the Supply Controller (SUPC) and Electrical Characteristics sections of the
datasheet.
The Supply Monitor monitors VDDIO. It is inactive by default. It can be activated by software and
is fully programmable with 16 steps for the threshold (between 1.9V to 3.4V). It is controlled by
the Supply Controller (SUPC). A sample mode is possible. It allows to divide the supply monitor
power consumption by a factor of up to 2048. For more information, refer to the Supply COntrol-
ler and Electrical Characteristics sections of the datasheet.
• Power-on-Reset on VDDIO
• Brownout Detector on VDDCORE
• Supply Monitor on VDDIO
Figure 7-1, "SAM3N4/2/1 Product Mapping" on page
26.
11011A–ATARM–04-Oct-10